Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Technical article
Subject
Tuning
Parent
Bosch Motronic 7
Applies to
Bosch ME7.1, Bosch ME7.5
Tool groups
None
Manufacturers
None

Scope and prerequisites

This is a log-review companion for the VAG ME7 examples in the MxT guide. Identify the exact ECU and matched logger definition first: signal names, trim representation, feedback strategy and sensor configuration vary. A believable MAF curve cannot compensate reliably for unknown injector data, fuel pressure, air leaks or exhaust leaks.

Closed-loop data

When the applicable lambda control is active, collect stable idle and part-load samples across the voltage and airflow range the vehicle actually reaches. The MxT workflow groups corrections by MAF voltage and filters rapidly changing samples. Keep the number and spread of observations as well as the average: a bin with sparse data or mixed operating states is weak evidence.

Example signalRole in the cited logger references
uhfm_w, mshfm_wMAF voltage and converted air mass; verify units and sensor range.
fr_w, fra_wLambda-regulator output and a multiplicative adaptation in the alias list; confirm sign, scaling and the relevant bank or region.
B_lrPre-catalyst lambda-control condition for bank 1 in the alias list. Other banks and software require their own definitions.
nmot, wdkba, temperaturesIdentify the operating state and exclude unsuitable transient or warm-up samples.

Keep the same hardware, fuel and calibration when combining comparable logs. Retain adaptation state and review each bank. A correction can also reflect injector, fuel-pressure, leak or sensor problems; it is not a direct measurement of MAF error.

Richer or open-loop operation

For an application whose fitted feedback cannot measure the rich mixture, use a correctly located and calibrated wideband. Compare its measured lambda with the applicable final requested lambda, not merely the driver-request table. If the wideband and ECU are recorded separately, match the same events and allow for time, transport and sensor delays. If using AFR, ensure the display and logger use a consistent stoichiometric reference for the fuel.

MxT’s ME7 procedure uses separate logger files and describes pairing corresponding pulls. Before accepting its proposed curve, inspect event matching, sample coverage and the effect on already-correct regions. A requested-versus-measured difference is an investigation, not proof that the MAF is the only error.

Sources and attribution

Adapted and rewritten from TracqiTechnology/MxT contributors’ ME7 Calibration Guide, Apache License 2.0, full text, with signal labels checked against the ME7Logger alias list. Additional M-box feedback context follows S4Wiki contributors’ Tuning, revision 5324, Creative Commons Attribution 4.0. For injector calibration, adaptation state and lambda paths see ME7 fueling and MAF calibration and ME7.1 S4 fueling and MAF examples.