Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Technical article
Subject
Tuning
Parent
Bosch ME7.1
Applies to
Bosch ME7.1
Tool groups
None
Manufacturers
Audi

Scope: the S4 M-box

This article describes the throttle-airflow and backup-load discussion for the Audi S4 2.7T M-box, identified by S4Wiki as 8D0907551M. It is a diagnostic reference, not a recommendation to disconnect the MAF or operate without fault detection. Map names, signal meanings and fallback logic must be checked in the identified ECU software. A separate Bosch ME7.3.1H Alfa function sheet uses some of the same signal names, but does not establish identical M-box logic.

Two ways of describing incoming air

The MAF path measures air passing the hot-film sensor. The throttle path estimates flow using throttle position and the applicable air-path model. The M-box source calls the latter alpha-N and describes it as a fallback if the primary MAF signal is unavailable. The two paths are not two independent physical flow meters.

Example signalWhat to check
mshfm_wMAF-derived mass flow and its conversion; establish units in the logger.
msdk_wThrottle-path airflow estimate; interpret with the model and its learned state.
wdkba, engine speedThrottle and RPM conditions at the same time as the airflow signals.
pvdks_w, pus_wPre-throttle and ambient pressure in the cited logger definitions, with their correct units.

Compare like units and reasonably stable operating points first. Transients, sampling or filtering differences, purge or other air paths, leaks, MAF conversion and throttle-model calibration can all affect the relationship. A mismatch is a reason to investigate these possibilities; its shape alone does not prove one particular map is wrong. Record fault codes and adaptations before resetting anything. ME7Logger alias list; Bosch ME7.3.1H Alfa function sheet, BGMSZS and EGFE signal descriptions.

WDKUGDN and throttle flow

For the M-box, S4Wiki describes WDKUGDN as a speed-dependent angle at the transition into an effectively unthrottled range. Its reported pressure-ratio threshold of 0.95 is specific to that documented implementation. KFMSNWDK and KFWDKMSN have separate roles in the throttle-flow relationships; check the function and axis definitions for the actual image before treating a curve as a correction.

Do not confuse this M-box transition with sonic choked flow. The MxT ME7 guide calls WDKUGDN a choke point, while the M-box reference distinguishes the two. NASA describes choked flow as the condition in which flow through a restriction reaches Mach 1 at its smallest area. The physical terms and the ECU’s transition should be evaluated separately. S4Wiki Alpha-N, revision 5321; NASA Glenn: mass-flow choking.

Check the function, not the abbreviation

MxT describes FUEREG as fuel adaptation in this discussion. The M-box reference instead identifies it as charge control, and Bosch’s separate ME7.3.1H Alfa sheet also describes a charge controller. Neither is evidence that a WDKUGDN change simply switches closed-loop lambda control off. Determine the actual flags and functions in the ECU being investigated; do not reset learned values or change a transition curve merely to hide a part-throttle airflow difference.

Sources and attribution

Based on S4Wiki contributors’ Alpha-N, revision 5321, Creative Commons Attribution 4.0; adapted, reorganised and qualified by Tuning Wiki. M-box software behaviour is reported by that source and has not been independently reproduced here. Additional tool context comes from TracqiTechnology/MxT contributors’ ME7 Calibration Guide, rewritten for this page; Apache License 2.0, full text. The Bosch function sheet cited above is for a different ME7.3.1H Alfa application.

Related: ME7 fueling and MAF calibration · ME7 torque, load and boost control · Adaptations and calibration drift.