Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Technical article
Subject
Supercharging
Parent
Section level
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
None

Part of the supercharger types and Eaton model guide.

What it is

The R900 is a 0.9-litre-per-turn TVS rotor family. Eaton lists single and compound arrangements; the surrounding manifold, bypass, cooling and calibration depend on who builds the particular system.

SpecificationDetail
Rotor familyTVS R-series Roots-type; four-lobe, 160-degree twist
Nominal supercharger displacement900 cm³ = 0.900 L / rotor revolution

Displacement: the blower volume is nominal air volume moved per rotor revolution. The engine figures below are cylinder capacity. Actual delivered air depends on speed, pressure, leakage and temperature.

Cars, engines and examples

These are documented examples, not a complete fitment catalogue. Factory equipment and aftermarket conversions are identified separately. Confirm market, vehicle, engine code and complete part number.

Vehicle and periodEngine displacement and typeInstallation and identificationEvidence
Mazda MX-5 Miata, 2016–20182.0 L SKYACTIV-G inline-fourAftermarket Edelbrock E-Force kit, not factory equipment. CARB identifies the kit's Eaton TVS R900 and vehicle range.CARB executive order
MINI Cooper S R53, example 20041.6 L W11 inline-fourAftermarket Harrop TVS900 replaces the original M45 in the documented test; it is not the standard R53 blower.Harrop R53 kit notes

Design and application

The R900's volume is larger than the M45's nominal 0.737 L/rev, but that comparison alone does not predict boost, power, efficiency or fit. Rotor design, inlet pressure, drive ratio, bypass and cooling determine the operating point.

Identification, maintenance and upgrades

Look for the manufacturer's exact kit, rotor designation, pulley and ECU calibration. An R900 kit for an MX-5 and one for a MINI are different assemblies. Monitor inlet temperature and belt condition and follow the selected kit's service guidance.

Before increasing speed or load, match the complete fuel, ignition, cooling, bypass and engine-calibration package to the intended use. Refer to the exact supplier's specifications; a generic pulley size or blower displacement is not a safe operating limit.

Sources