Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Technical article
Subject
Supercharging
Parent
Section level
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
None

Part of the supercharger types and Eaton model guide.

What it is

The M122 is a nominal 122-cubic-inch, approximately 2.0-litre-per-revolution Roots-type unit. It was fitted to the earlier modern Shelby GT500's 5.4-litre V8; later GT500 engines used a different TVS design.

SpecificationDetail
Rotor familyM-series Roots-type, distinct from TVS
Nominal supercharger displacement122 in³ ≈ 1.999 L / rotor revolution

Displacement: the blower volume is nominal air volume moved per rotor revolution. The engine figures below are cylinder capacity. Actual delivered air depends on speed, pressure, leakage and temperature.

Cars, engines and examples

These are documented examples, not a complete fitment catalogue. Factory equipment and aftermarket conversions are identified separately. Confirm market, vehicle, engine code and complete part number.

Vehicle and periodEngine displacement and typeInstallation and identificationEvidence
Ford Shelby GT500, 2007–20125.4 L Modular DOHC V8Factory M122. VMP identifies the 2007–2012 stock unit; Ford identifies the 5.4-litre engine.VMP stock M122 application; Ford history

Design and application

The M122 uses the older M-series label rather than the later TVS designation. Ford's 2013 GT500 changed to a 5.8-litre V8 with an Eaton TVS 2300, so the name GT500 alone does not identify the blower. A rotor size is not an adapter, calibration or complete kit.

Identification, maintenance and upgrades

Confirm year, casting, mounting, throttle-body position, bypass and drive offset. Inspect the input drive, bearings, cooling and bypass. Consider fuel, ignition, intake temperature, belt wrap and maximum rotor speed together when considering an upgrade.

Before increasing speed or load, match the complete fuel, ignition, cooling, bypass and engine-calibration package to the intended use. Refer to the exact supplier's specifications; a generic pulley size or blower displacement is not a safe operating limit.

Sources