Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Technical article
Subject
Supercharging
Parent
Section level
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
None

Part of the supercharger types and Eaton model guide.

What it is

The M24 is a compact early Eaton Roots-type unit. Its approximately 0.393-litre rotor displacement describes one blower rotation, not the size of the engine. Eaton reported its introduction on the Brazilian Ford Fiesta.

SpecificationDetail
Rotor familyM-series Roots-type; nominal positive displacement
Nominal supercharger displacement24 in³ ≈ 0.393 L / rotor revolution

Displacement: the blower volume is nominal air volume moved per rotor revolution. The engine figures below are cylinder capacity. Actual delivered air depends on speed, pressure, leakage and temperature.

Cars, engines and examples

These are documented examples, not a complete fitment catalogue. Factory equipment and aftermarket conversions are identified separately. Confirm market, vehicle, engine code and complete part number.

Vehicle and periodEngine displacement and typeInstallation and identificationEvidence
Ford Fiesta Supercharger, Brazil, 2002 launch1.0 L Zetec Rocam inline-fourFactory example. Eaton's 2002 annual report names the Fiesta M24; a parts manufacturer's application list separately identifies the 1.0 Supercharger engine.Eaton; Tuper

Design and application

The small rotor capacity can suit compact-engine projects, but the mounting, inlet and drive were engineered for the donor. It is not automatically suitable for every 1.0-litre engine. Verify the housing, pulley, bypass and clearance before planning a swap.

Identification, maintenance and upgrades

Inspect rotor coating and case for contact, the input bearings, seals and coupling, and the bypass where fitted. Obtain lubrication and speed limits for the actual part number; do not transfer them from a larger M-series or a TVS unit.

Before increasing speed or load, match the complete fuel, ignition, cooling, bypass and engine-calibration package to the intended use. Refer to the exact supplier's specifications; a generic pulley size or blower displacement is not a safe operating limit.

Sources