Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Reference hub
Subject
Engine ECU
Parent
Sagem
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
None

Changes from revision 1 to revision 2

Removed text is struck through; added text is highlighted.

What Safir is

Safir is the Sagem multipoint petrol controller used on the smaller Renault engines before S2000. The Kangoo workshop text for the D7F describes a Sagem or Magneti Marelli 35-pin computer on the car without the listed option, and a 55-pin computer of Sagem type Safir, or Magneti Marelli, on the CA version. Injection is semi-sequential: the injectors are driven as two pairs, cylinders 1 and 4, then cylinders 2 and 3. Ignition is a static twin-coil pack. The same heading also names the E7J. The sensor layout below is the D7F description. Do not copy it onto an E7J, or onto a 55-pin Siemens Fenix 5, which that manual describes as a different computer on another engine.

Repair catalogues and a 2007 Renault ECU tool manual do not use the pin counts the same way. The tool manual calls the 55-pin unit Safir and a potted 35-pin unit Safir2. Cotrolia lists a 35-pin Safir 1 for Clio, Kangoo and Twingo, a 35-pin Safir 2 for Clio and Twingo, and a 55-pin Safir 2 for Twingo. The numeral is not a reliable guide to the connector. The label and the pin count are.

ProcessorA document listing ECUs by processor type places the Sagem Safir 1 and Safir 2, together with the Siemens Fenix 5, among Renault ECUs with a TMS374 processor. This is a secondary, single-source listing; the exact device and memory part are not stated.

What the D7F system uses

The Kangoo D7F layout names a coil pack, the air filter, an oxygen sensor, a manifold-absolute-pressure sensor, a throttle-position potentiometer, an idle stepper, an air-temperature sensor, the injection computer, an inertia switch, a lock relay, a fuel-pump relay, a top-dead-centre sensor, a canister-purge valve, a coolant-temperature sensor, a knock sensor, a power-steering pressure switch and a fuel-pressure regulator. Load is manifold pressure, not a flap or a hot wire. The idle stepper is the extra air for a cold idle, a hot idle under load, and the transient correction. There is no motorised throttle in this description.

The computer is configured for a manual or an automatic gearbox. Idle speed is corrected for battery voltage, air conditioning and the power-steering pressure switch. The stated maximum engine speed is 6200 rpm. The canister purge valve is driven by a duty cycle. The injection warning lamp on this D7F installation is described as not functional. Diagnosis uses socket 27.

Immobiliser

The Kangoo text says this engine adopted a second-generation coded immobiliser, and that replacing the computer has its own procedure because of it. A Safir unit from another car is not a plug-in exchange. The coding is a Renault procedure for that immobiliser generation. It is not a map change, and the 35-pin and 55-pin units are not a substitute for each other because one of them happens to start.

What came next

Sagem S2000 is the sequential controller with, on the Laguna, a 112-track case and a motorised throttle. Safir remains the semi-sequential, cable-throttle, manifold-pressure system. A Kangoo or Clio that has been given a later engine can carry either, or a Magneti Marelli unit in the same connector family. Read the case.

Not establishedA complete published 35-pin or 55-pin connector pinout for Safir is not established; decoder guides give only the ground, immobiliser and switched supply pins.

Sources

Renault Kangoo workshop text, multipoint injection particulars for the D7F, as republished at Kangoo Info. Pin counts, semi-sequential injection, the 6200 rpm limit and the sensor layout. Accessed 2026-11-13. Cotrolia repair listings for Safir 1, 35 pins, and Safir 2, 35 pins and 55 pins. The conflicting connector names. Accessed 2026-11-13. A 2007 Renault injection-ECU tool manual, which names Safir as the 55-pin unit and Safir2 as the 35-pin unit. Used here only for that naming. The decoding procedure in that manual is not a repair method and is not repeated. TMS374 ECU list, Scribd document, listing of ECUs by processor type; seen in search summary. Accessed 19 November 2026.Renault Kangoo workshop text, multipoint injection particulars for the D7F, as republished at Kangoo Info. Pin counts, semi-sequential injection, the 6200 rpm limit and the sensor layout. Accessed 2026-11-13. Cotrolia repair listings for Safir 1, 35 pins, and Safir 2, 35 pins and 55 pins. The conflicting connector names. Accessed 2026-11-13. A 2007 Renault injection-ECU tool manual, which names Safir as the 55-pin unit and Safir2 as the 35-pin unit. Used here only for that naming. The decoding procedure in that manual is not a repair method and is not repeated.

Rendered revisions

Open each version to inspect formatting, tables and photographs.

Revision 1: Sagem Safir

What Safir is

Safir is the Sagem multipoint petrol controller used on the smaller Renault engines before S2000. The Kangoo workshop text for the D7F describes a Sagem or Magneti Marelli 35-pin computer on the car without the listed option, and a 55-pin computer of Sagem type Safir, or Magneti Marelli, on the CA version. Injection is semi-sequential: the injectors are driven as two pairs, cylinders 1 and 4, then cylinders 2 and 3. Ignition is a static twin-coil pack. The same heading also names the E7J. The sensor layout below is the D7F description. Do not copy it onto an E7J, or onto a 55-pin Siemens Fenix 5, which that manual describes as a different computer on another engine.

Repair catalogues and a 2007 Renault ECU tool manual do not use the pin counts the same way. The tool manual calls the 55-pin unit Safir and a potted 35-pin unit Safir2. Cotrolia lists a 35-pin Safir 1 for Clio, Kangoo and Twingo, a 35-pin Safir 2 for Clio and Twingo, and a 55-pin Safir 2 for Twingo. The numeral is not a reliable guide to the connector. The label and the pin count are.

What the D7F system uses

The Kangoo D7F layout names a coil pack, the air filter, an oxygen sensor, a manifold-absolute-pressure sensor, a throttle-position potentiometer, an idle stepper, an air-temperature sensor, the injection computer, an inertia switch, a lock relay, a fuel-pump relay, a top-dead-centre sensor, a canister-purge valve, a coolant-temperature sensor, a knock sensor, a power-steering pressure switch and a fuel-pressure regulator. Load is manifold pressure, not a flap or a hot wire. The idle stepper is the extra air for a cold idle, a hot idle under load, and the transient correction. There is no motorised throttle in this description.

The computer is configured for a manual or an automatic gearbox. Idle speed is corrected for battery voltage, air conditioning and the power-steering pressure switch. The stated maximum engine speed is 6200 rpm. The canister purge valve is driven by a duty cycle. The injection warning lamp on this D7F installation is described as not functional. Diagnosis uses socket 27.

Immobiliser

The Kangoo text says this engine adopted a second-generation coded immobiliser, and that replacing the computer has its own procedure because of it. A Safir unit from another car is not a plug-in exchange. The coding is a Renault procedure for that immobiliser generation. It is not a map change, and the 35-pin and 55-pin units are not a substitute for each other because one of them happens to start.

What came next

Sagem S2000 is the sequential controller with, on the Laguna, a 112-track case and a motorised throttle. Safir remains the semi-sequential, cable-throttle, manifold-pressure system. A Kangoo or Clio that has been given a later engine can carry either, or a Magneti Marelli unit in the same connector family. Read the case.

Sources

  • Renault Kangoo workshop text, multipoint injection particulars for the D7F, as republished at Kangoo Info. Pin counts, semi-sequential injection, the 6200 rpm limit and the sensor layout. Accessed 2026-11-13.
  • Cotrolia repair listings for Safir 1, 35 pins, and Safir 2, 35 pins and 55 pins. The conflicting connector names. Accessed 2026-11-13.
  • A 2007 Renault injection-ECU tool manual, which names Safir as the 55-pin unit and Safir2 as the 35-pin unit. Used here only for that naming. The decoding procedure in that manual is not a repair method and is not repeated.
Revision 2: Sagem Safir

What Safir is

Safir is the Sagem multipoint petrol controller used on the smaller Renault engines before S2000. The Kangoo workshop text for the D7F describes a Sagem or Magneti Marelli 35-pin computer on the car without the listed option, and a 55-pin computer of Sagem type Safir, or Magneti Marelli, on the CA version. Injection is semi-sequential: the injectors are driven as two pairs, cylinders 1 and 4, then cylinders 2 and 3. Ignition is a static twin-coil pack. The same heading also names the E7J. The sensor layout below is the D7F description. Do not copy it onto an E7J, or onto a 55-pin Siemens Fenix 5, which that manual describes as a different computer on another engine.

Repair catalogues and a 2007 Renault ECU tool manual do not use the pin counts the same way. The tool manual calls the 55-pin unit Safir and a potted 35-pin unit Safir2. Cotrolia lists a 35-pin Safir 1 for Clio, Kangoo and Twingo, a 35-pin Safir 2 for Clio and Twingo, and a 55-pin Safir 2 for Twingo. The numeral is not a reliable guide to the connector. The label and the pin count are.

Processor

A document listing ECUs by processor type places the Sagem Safir 1 and Safir 2, together with the Siemens Fenix 5, among Renault ECUs with a TMS374 processor. This is a secondary, single-source listing; the exact device and memory part are not stated.

What the D7F system uses

The Kangoo D7F layout names a coil pack, the air filter, an oxygen sensor, a manifold-absolute-pressure sensor, a throttle-position potentiometer, an idle stepper, an air-temperature sensor, the injection computer, an inertia switch, a lock relay, a fuel-pump relay, a top-dead-centre sensor, a canister-purge valve, a coolant-temperature sensor, a knock sensor, a power-steering pressure switch and a fuel-pressure regulator. Load is manifold pressure, not a flap or a hot wire. The idle stepper is the extra air for a cold idle, a hot idle under load, and the transient correction. There is no motorised throttle in this description.

The computer is configured for a manual or an automatic gearbox. Idle speed is corrected for battery voltage, air conditioning and the power-steering pressure switch. The stated maximum engine speed is 6200 rpm. The canister purge valve is driven by a duty cycle. The injection warning lamp on this D7F installation is described as not functional. Diagnosis uses socket 27.

Immobiliser

The Kangoo text says this engine adopted a second-generation coded immobiliser, and that replacing the computer has its own procedure because of it. A Safir unit from another car is not a plug-in exchange. The coding is a Renault procedure for that immobiliser generation. It is not a map change, and the 35-pin and 55-pin units are not a substitute for each other because one of them happens to start.

What came next

Sagem S2000 is the sequential controller with, on the Laguna, a 112-track case and a motorised throttle. Safir remains the semi-sequential, cable-throttle, manifold-pressure system. A Kangoo or Clio that has been given a later engine can carry either, or a Magneti Marelli unit in the same connector family. Read the case.

Not established

A complete published 35-pin or 55-pin connector pinout for Safir is not established; decoder guides give only the ground, immobiliser and switched supply pins.

Sources

  • Renault Kangoo workshop text, multipoint injection particulars for the D7F, as republished at Kangoo Info. Pin counts, semi-sequential injection, the 6200 rpm limit and the sensor layout. Accessed 2026-11-13.
  • Cotrolia repair listings for Safir 1, 35 pins, and Safir 2, 35 pins and 55 pins. The conflicting connector names. Accessed 2026-11-13.
  • A 2007 Renault injection-ECU tool manual, which names Safir as the 55-pin unit and Safir2 as the 35-pin unit. Used here only for that naming. The decoding procedure in that manual is not a repair method and is not repeated.
  • TMS374 ECU list, Scribd document, listing of ECUs by processor type; seen in search summary. Accessed 19 November 2026.