Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Technical article
Subject
Tuning Tools
Parent
Section level
Applies to
No ECU-specific applicability
Tool groups
Flashing and tuning tools
Manufacturers
AMT-Cartech
AMT-Cartech MPPS OBD interface
AMT-Cartech MPPS. Image credit: AMT-Cartech. Image source.

AMT-Cartech builds OBD programming tools. The company says that in 1998 it introduced an OBD flash tool called KWP2000, named for the Keyword Protocol 2000 controllers it addressed, and that MPPS (Multi Protocol Programming System) followed as newer protocols appeared. MPPS is now described as a third generation, with a redesigned case and PCB. AMT names software version V22 and an additional plugin for Infineon TriCore boot programming.

MPPS

AMT describes reading and writing, checksum support, full or partial reads where the controller allows them, and recovery on some controllers, including cases it says can be attempted when the program memory is blank. It also lists boot mode for some C167 and ST10 controllers, EEPROM access on some controllers, and a check of the VAG MEDC17 tuning-protection level without opening the unit. The manufacturer sells slave, standalone master, master and virtual master configurations. Open files, encrypted files and whether slave tools can be attached depend on that configuration. Confirm the comparison table on the current MPPS page rather than assuming every configuration can write.

A distributor also lists an AMT BDM interface and an AMT Bench Service Tool as separate master interfaces that read and write open binary files, with no annual fee stated on those listings. Those distributor descriptions do not replace AMT’s own protocol list.

Sources