
Haltech Nexus T1 is a programmable engine-management ECU in Haltech's Nexus family. Haltech lists 5 analogue voltage inputs and 2 differential engine-position inputs. The T1 has no half-bridge outputs or integrated power distribution in the comparison. Haltech universal comparison.
Identification and I/O
| Item | Manufacturer comparison |
|---|---|
| Injector channels | 4, peak-and-hold |
| Ignition channels | 4 |
| Digital pulsed outputs | 5 |
| MAP sensor | 4 bar internal |
| Tuning software | Nexus Software Programmer (NSP); verify installed firmware |
Counts do not imply that all functions are available simultaneously: driver allocation, injector impedance, ignition type, firmware and calibration must suit the installation.
Pinout and wiring
Use the manufacturer wiring diagrams and select the Nexus T1 ECU and actual harness or part number. Drawings for other models and plug-in adaptors are not a substitute for the identified unit. Verify connector orientation, power and grounds, current limits and output assignment before connection.
Software and further information
Download the matching software and firmware through Haltech downloads. For family context and other models see Haltech standalone ECUs. Compare the label, serial, connectors and map backup before replacing a controller.
T1/T2 main power pins
Haltech identifies A26 as the fused supply switched by the engine-control relay and A10 as ECU ground to battery negative. These positions refer to the manufacturer T1/T2 connector, not another Nexus model. See Nexus T1/T2 pinout and installation guide for the full connector diagram, trigger wiring and electrical limits.
The full 34-pin assignment of connector A, shared by the Nexus T2 and T1 and redrawn from Haltech's wiring diagram revision 2.0 (August 2026), is in Haltech Nexus T2 and T1 connector pinout; on the T1, injector and ignition outputs 5 and 6 are not available.