Haltech Nexus S3 is a programmable engine-management ECU in Haltech's Nexus family. Designed for up to 8 cylinders with full sequential fuel and ignition; up to 12 cylinders may use semi-sequential or batch injection. One onboard wideband controller, two knock inputs, 11 analogue inputs, six synchronised inputs and up to two DBW throttles. Haltech universal comparison.

Identification and I/O
| Item | Manufacturer comparison |
|---|---|
| Injector channels | 8, peak-and-hold |
| Ignition channels | 8 |
| Digital pulsed outputs | 6 |
| MAP sensor | 4 bar internal |
| Tuning software | Nexus Software Programmer (NSP); verify installed firmware |
Haltech identifies the S-series as successors to the Elite 1500/2500, but says the ECU-side connectors differ and the harness must be repinned. The S-series has no onboard power-distribution module; check current and output ratings in the appropriate guide. S-series specification and upgrade notes.
Counts do not imply that all functions are available simultaneously: driver allocation, injector impedance, ignition type, firmware and calibration must suit the installation.
Pinout and wiring
Use the manufacturer wiring diagrams and select the Nexus S3 ECU and actual harness or part number. Drawings for other models and plug-in adaptors are not a substitute for the identified unit. Verify connector orientation, power and grounds, current limits and output assignment before connection.
The full 68-pin assignment of connectors A and C, shared by the Nexus S3 and S2 and redrawn from Haltech's HT-182200 wiring diagram (August 2024), is in Haltech Nexus S3 and S2 connector pinout.
Software and further information
Download the matching software and firmware through Haltech downloads. For family context and other models see Haltech standalone ECUs. Compare the label, serial, connectors and map backup before replacing a controller.