
ME442 plug-in ECU for Toyota Glanza EP91. This application-specific unit replaces the factory ECU electronics while using the vehicle's original harness connector, subject to exact fitment and configuration. Motorsport Electronics product information · application installation guide.
Identification and application
ME supplies an EP91 plug-in alongside the EP82 variant. The GEN2 guide covers both; identify the actual original ECU and loom before transferring assignments. Record the serial, board version, firmware, factory ECU part number, engine and transmission before installing. The ME221 and ME442 are separate hardware choices; the manufacturer lists wideband, onboard logging and EGT as ME442 plug-in features. Optional electronic throttle equipment and supported functions vary by board and configuration. See ME's model comparison and downloads.
Connector and pinout
Use the OEM header and auxiliary connector diagrams in the exact application installation guide. Connector view, jumper/switch settings, sensors and supported functions vary by generation and vehicle. The universal 28-way and 90-way wire-in tables do not define this plug-in board's factory header.
Auxiliary connector assignments
The ME GEN2 installation guide lists this 20-way Molex Mini-Fit Jr connector. Check the original diagram for orientation, the actual model and fitted options: the table describes the documented connector, not a guarantee every function is supported on every ME221 or ME442 core.
| Pin | Function in manufacturer guide |
|---|---|
| 1 | Injector 5 — 3.5 A FB protected |
| 2 | Injector 6 — 3.5 A FB protected |
| 3 | Injector 7 — 3.5 A FB protected |
| 4 | Injector 8 — 3.5 A FB protected |
| 5 | NC |
| 6 | NC |
| 7 | LS1 — 2 A PWM-capable |
| 8 | LS2 — 2 A PWM-capable |
| 9 | LS3 — 2 A PWM-capable |
| 10 | K-type EGT signal — ME442 only |
| 11 | DI 1 — 1 kΩ 5 V pull-up |
| 12 | DI 2 — 1 kΩ 5 V pull-up |
| 13 | DI 3 not available — boost button |
| 14 | Analogue volt 5 — 0–5 V |
| 15 | Analogue volt 6 — 0–5 V |
| 16 | Analogue volt 7 — 0–5 V |
| 17 | CAN 1 low — unterminated |
| 18 | CAN 1 high — unterminated |
| 19 | 5 V reference — 100 mA max |
| 20 | EGT and sensor ground |
The guide states that the connector orientation differs between EP82 and EP91; follow the appropriate original diagram. EGT is marked for ME442 versions.
Processor
Motorsport Electronics does not publish the microcontroller part number. A retailer listing for the ME442 plug-in describes a 180 MHz RISC processor; this is a single-source vendor description rather than a component identification. Dynotronics ME442 plug-and-play ECU listing, accessed 19 November 2026.
Structured connector pinout
Every cavity of the EP82 and EP91 factory headers and the 20-way auxiliary connector, with the manufacturer's assignments, is drawn in Motorsport Electronics ME221 and ME442 EP82/EP91 plug-in connector pinout.
Software and installation
Use the correct MEITE / EZ Tune release and the model-specific firmware and base map. The installation guide covers sensor settings, baseline checks, expansion, jumper settings and any vehicle-specific exceptions; a base map still needs calibration and verification on the actual engine. See the ME442 family page for wire-in generation and hardware context.
Sources reviewed 17 November 2026.