Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Reference hub
Subject
Engine ECU
Parent
Sagem
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
None

What Safir is

Safir is the Sagem multipoint petrol controller used on the smaller Renault engines before S2000. The Kangoo workshop text for the D7F describes a Sagem or Magneti Marelli 35-pin computer on the car without the listed option, and a 55-pin computer of Sagem type Safir, or Magneti Marelli, on the CA version. Injection is semi-sequential: the injectors are driven as two pairs, cylinders 1 and 4, then cylinders 2 and 3. Ignition is a static twin-coil pack. The same heading also names the E7J. The sensor layout below is the D7F description. Do not copy it onto an E7J, or onto a 55-pin Siemens Fenix 5, which that manual describes as a different computer on another engine.

Repair catalogues and a 2007 Renault ECU tool manual do not use the pin counts the same way. The tool manual calls the 55-pin unit Safir and a potted 35-pin unit Safir2. Cotrolia lists a 35-pin Safir 1 for Clio, Kangoo and Twingo, a 35-pin Safir 2 for Clio and Twingo, and a 55-pin Safir 2 for Twingo. The numeral is not a reliable guide to the connector. The label and the pin count are.

Processor

A document listing ECUs by processor type places the Sagem Safir 1 and Safir 2, together with the Siemens Fenix 5, among Renault ECUs with a TMS374 processor. This is a secondary, single-source listing; the exact device and memory part are not stated.

What the D7F system uses

The Kangoo D7F layout names a coil pack, the air filter, an oxygen sensor, a manifold-absolute-pressure sensor, a throttle-position potentiometer, an idle stepper, an air-temperature sensor, the injection computer, an inertia switch, a lock relay, a fuel-pump relay, a top-dead-centre sensor, a canister-purge valve, a coolant-temperature sensor, a knock sensor, a power-steering pressure switch and a fuel-pressure regulator. Load is manifold pressure, not a flap or a hot wire. The idle stepper is the extra air for a cold idle, a hot idle under load, and the transient correction. There is no motorised throttle in this description.

The computer is configured for a manual or an automatic gearbox. Idle speed is corrected for battery voltage, air conditioning and the power-steering pressure switch. The stated maximum engine speed is 6200 rpm. The canister purge valve is driven by a duty cycle. The injection warning lamp on this D7F installation is described as not functional. Diagnosis uses socket 27.

Immobiliser

The Kangoo text says this engine adopted a second-generation coded immobiliser, and that replacing the computer has its own procedure because of it. A Safir unit from another car is not a plug-in exchange. The coding is a Renault procedure for that immobiliser generation. It is not a map change, and the 35-pin and 55-pin units are not a substitute for each other because one of them happens to start.

What came next

Sagem S2000 is the sequential controller with, on the Laguna, a 112-track case and a motorised throttle. Safir remains the semi-sequential, cable-throttle, manifold-pressure system. A Kangoo or Clio that has been given a later engine can carry either, or a Magneti Marelli unit in the same connector family. Read the case.

Not established

A complete published 35-pin or 55-pin connector pinout for Safir is not established; decoder guides give only the ground, immobiliser and switched supply pins.

Sources

  • Renault Kangoo workshop text, multipoint injection particulars for the D7F, as republished at Kangoo Info. Pin counts, semi-sequential injection, the 6200 rpm limit and the sensor layout. Accessed 2026-11-13.
  • Cotrolia repair listings for Safir 1, 35 pins, and Safir 2, 35 pins and 55 pins. The conflicting connector names. Accessed 2026-11-13.
  • A 2007 Renault injection-ECU tool manual, which names Safir as the 55-pin unit and Safir2 as the 35-pin unit. Used here only for that naming. The decoding procedure in that manual is not a repair method and is not repeated.
  • TMS374 ECU list, Scribd document, listing of ECUs by processor type; seen in search summary. Accessed 19 November 2026.