Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Reference hub
Subject
Engine ECU
Parent
Autronic standalone ECUs
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
None

Autronic SM4MR is a standalone or earlier programmable engine-management system. Marine SM4 with sealed anodised case; the manufacturer lists eight injector outputs and four ignition outputs. Model-specific information.

Identification and features

Record the ECU label, model, part number, hardware revision, firmware, configured injectors, ignition hardware and loom before comparing systems. Some outputs can be reassigned; hardware, software, current limits and engine-specific options determine what is actually available.

Processor

Autronic's SM4MR product page (manufacturer documentation) gives a 16-bit Intel microcontroller running at 20 MHz. The exact part number is not stated in the sources checked.

Engine applications

The SM4MR is the marinised version of the SM4, originally developed for international personal watercraft racing and suited to off-road racing and other high-performance motorsport. Per Autronic it supports most reciprocating engines of 1 to 8, 10, 12, 14 and 16 cylinders (two-stroke, four-stroke and rotary) and two-rotor rotary engines, with turbo boost control. Injector drivers are arranged as two groups of four with selectable peak/hold current; unused injector outputs can be reassigned as additional outputs or switch inputs. Ignition has four push-pull outputs with 3D-mappable dwell or pulse time. Main connector: 42-way sealed; serial: 8 mm 3-way sealed. Manned-aircraft use is prohibited. No engine codes are listed.

Connector pinout

The 42-position function table is on the Autronic SM4 connector pinout page, which covers the SM4, SM4DC and SM4 Marine versions with the standard SM4 loom (manufacturer documentation; diagram redrawn by Tuning Wiki). On dual-calibration versions pin 39 selects calibration instead of HSI 3. Use the original connector drawing for orientation and output limits, and identify the exact unit, part and version before wiring.

Further information

Sources