Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Reference hub
Subject
Engine ECU
Parent
AEM Performance Electronics standalone ECUs
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
None
AEM Infinity family ECU marketing image
AEM Infinity ECU family illustration, showing multiple models; not necessarily Infinity 506. Image: AEM / Holley, reproduced with permission.

AEM Infinity 506 (manufacturer part 30-7106) is a programmable Infinity engine-management ECU, a separately identified model in AEM's hardware comparison.

Identification and capability

Manufacturer specificationInfinity 506
Maximum cylinders, as listed6
Sequential injector outputs6 high- or low-impedance
Ignition6 logic-level
Connector positions80
Electronic throttleSingle
CAN channels2
Internal wideband channels1

Compare injector impedance and ignition driver type before connecting components. Maximum cylinder count does not imply every feature or configuration is available simultaneously; verify exact part number, harness and calibration. AEM lists InfinityTuner software separately from Series 1/2 EMS software.

Processor

Retailer listings reproducing AEM's product description state that the Infinity range is built around a 32-bit floating-point automotive processor running at 200 MHz and rated at 400 MIPS (vendor claim). Neither those listings nor AEM's hardware specification name the manufacturer or part number of the processor, so the exact microcontroller is not established.

Engine applications

The universal 506 is intended for engines of up to six cylinders with sequential injection and electronic throttle control. AEM also sells vehicle-specific plug-and-play harness kits that fit the same ECU, for example the 30-3517 kit for the Nissan SR20DET described below. Engine codes are otherwise defined by the installer's configuration.

Connector and wiring

AEM's Infinity 506 family hardware and wiring reference gives electrical limits and connector diagrams. Match the ECU's number and physical harness, and verify connector orientation. The 506 and 508 share an 80-way shell but some pin assignments differ; Series 3 and Series 7 use different connectors and are not interchangeable by name.

Example connector differences

For the specific Nissan SR20DET PNP harness documented by AEM, C1-3 and C1-4 are low-side outputs 6 and 7; C1-10 is permanent battery power and C1-11 through C1-14 are ignition coil signals 4, 3, 2, 1. The source says C1-10 must be powered before ignition is switched on and that the coil signals cannot drive a coil primary directly. These are ECU connector functions in the 30-3517 application-specific wiring guide, not a universal factory vehicle pinout.

Connector pinout

The full 80-position C1 pin table with a redrawn pin-index diagram is on AEM Infinity 506 connector pinout (manufacturer documentation; diagram redrawn by Tuning Wiki).

Further documents

Sources reviewed 17 November 2026. Availability of an exact part or application should be checked separately.

AEM formerly called this Infinity-6; part number 30-7106 was retained. AEM model-name change announcement.

Sources