Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Technical article
Subject
Tuning
Parent
Bosch MED9.1
Applies to
Bosch MED9.1
Tool groups
None
Manufacturers
Audi, Volkswagen

Scope: identify the engine and control

Volkswagen's SSP 337 describes continuously variable intake cam adjustment on its AXX 2.0 TFSI example, which uses MED9.1. That is an example, not a specification for every MED9.1 installation. The long NefMoto KFNWSE discussion includes switched-cam ME7 examples, so its switching observations and numbers must not be treated as 2.0 TFSI MED9.1 calibration values.

Map names, selection and references

In Bosch's MED9.1 41W038_PQ35 function description, NWSOLLE page 1363, KFNWSE is an intake cam-spread map and KFNWWLE is an intake cam-spread map for the warm-up phase. Both are listed against engine speed and the function's relative-charge signal. The same description also lists separate idle, catalyst-heating and other maps and a factor for transition between cold and warm maps. A familiar map name alone therefore does not prove which value is active at a given operating point.

The Bosch application notes, page 1370, say the breakpoint groups for several maps are configurable and cam-position values are engine-specific. The precise ECU software, definition, dimensions, axes, units, operating state and reference must be verified before values are interpreted or files compared.

Sign convention is a further trap. In a separate NefMoto MED9 discussion about V8/V12 FSI engines and how a negative map value relates to crank angle, the replies do not establish a universal sign convention for a 2.0 TFSI. Bosch documents different reference positions and measurement conventions in NWSOLLE pages 1368–1369, so advance or retard cannot be inferred from the sign without identifying the actual signal and reference.

Comparing commanded and actual timing

  1. Record engine code, mechanical parts, ECU software, diagnostic faults and the baseline condition. Check cam-to-crank timing and the adjuster's mechanical and oil-system condition against the correct workshop information before changing calibration.
  2. Where the ECU exposes them, log requested and actual cam position together with engine speed, load, temperature, operating mode and relevant intervention or fault states. Identify the units, reference and update rate of each channel; compare like-for-like operating conditions.
  3. If the requested angle differs from the table you expected, first investigate map selection, blending and operating conditions. If actual position fails to follow the request, investigate control and hardware as well as calibration. Neither comparison alone establishes the cause.

Camshaft swaps and the fuel pump

In a NefMoto AXX camshaft-swap case, an owner asked about transferring Golf 6 R cam maps, and a reply raised the high-pressure pump's cam geometry. The case does not document a completed, verified calibration. The fitted cam, follower and pump geometry and the relevant software model should be confirmed before deciding whether a calibration change is required; donor map values are not a validated drop-in solution. See MED9.1 fuel pressure and logging for the pump and pressure-control context, and ignition map selection and knock diagnosis for the associated ignition-map context.

Not established

  • A universal cam-angle target or vehicle-tested tuning setting.
  • A verified calibration for the AXX camshaft swap.
  • A universal sign convention for cam-position maps on the 2.0 TFSI.

Sources describe the cited examples and Bosch software version. Sources reviewed 17 November 2026.