Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Technical article
Subject
Datalogging and telematics
Parent
Section level
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
Renault

What it is

RSTuner is software used by Renault Sport owners and tuners to read fault codes and log engine data from the diagnostic socket. Its diagnostic ability is closer to a generic reader, while its interface and usability are closer to Renault CLIP, placing it between the two. For the official workshop tool see Renault CLIP and the Alliance diagnostic tool, and for the open-source option see DDT4All. No official documentation is available, so the details below rest on owner reports.

Capabilities reported

  • Renault-specific interpretation of fault codes, which is more accurate than a generic reader.
  • Paid add-on modules that unlock ABS, ESP and traction faults, airbag faults and airbag fault removal, and longitudinal and lateral accelerometer data.
  • Logging of the usual parameters (oxygen sensor, vehicle speed, manifold pressure and temperature) with a larger on-screen display and CSV export. It has also been used to check that the knock sensor is acting, and to log knock and injector duty.
  • On Clios the socket is under the ashtray.

Limits reported

  • It cannot disable the gearshift beep on a Clio III RS, which CLIP can, and it cannot reset a crashed airbag control unit.
  • For the 172, 182, 197 and 200 there is said to be no configuration backup function.

Role in tuning

Tuners ask the owner to log a drive, then use the logs to adjust the calibration. Manufacturer-specific logging, as opposed to generic OBD-II, exposes channels such as ignition advance, ignition withdrawal (the knock-related retard) and a knock counter. AutoTuner's Renault Group logging page lists those categories for the Sagem S3000 (see Sagem tool support), but it does not state that RSTuner reads the same channels, and the comparison was not checked. A 182 manifold change calls for different fuel map settings, which shows why per-car logs matter. Logs from different maps are not clean evidence of a better map unless knock behaviour is also compared.

Not established

  • The hardware interface, the full module list and prices.
  • Whether RSTuner reads the same knock and ignition channels as the Sagem S3000 logging described above.

Sources