A camshaft that opens the valves further or faster asks more of the valve springs. The spring has to close the valve, hold it on its seat and keep the valvetrain in contact with the cam lobe at the engine speeds in use. This page explains the terms and the failure modes. Cam geometry is on camshafts and valve timing, and the camshaft itself on camshafts.
Seat pressure and open pressure
Spring force is described at two points (Fastime Performance valve spring guide):
- Seat pressure is the force with the valve closed, at installed height. It keeps the valve sealed and stable at low lift.
- Open pressure is the force at maximum lift. It controls the valve at high engine speed.
Both must be right. Enough seat pressure cannot make up for too little open pressure, and the reverse also holds.
Float and bounce
- Valve float happens when open pressure is too low for the engine speed. The spring cannot return the valve before the cam acts again, which causes power loss at high rpm and, in extreme cases, engine damage.
- Valve bounce happens when seat pressure is too low. The valve rebounds on closing, which loses compression sealing and makes the valve motion unstable.
The load the spring has to control includes everything that moves with the valve: the valve, the retainer and the share of the spring and rocker. A lighter moving mass needs less spring force for the same engine speed, but part choices are the maker's to specify for the cam and spring used, so do not swap retainers or springs without checking the whole set.
Installed height
Installed height is the length of the spring with the valve closed. It changes with the retainer, seat and cylinder-head work, and it changes the forces: a shorter installed height raises both seat and open pressure, and a taller one lowers both. After any change to retainers, seats or valve work, measure the installed height and recalculate. Follow the camshaft maker's recommendations, then verify with measurements. Do not run a spring so close to its full compression that the coils touch (coil bind), because that is a mechanical limit, not a margin; the camshaft or spring maker gives the safe lift for each spring.
More pressure is not free
Excessive spring pressure increases wear on the camshaft and lifters, adds stress to pushrods and rockers, shortens component life and adds friction and heat. The right pressure is the least that controls the valve across the range, not the highest available. A rebuilt cylinder head can still float valves if the springs have weakened with use, so check spring pressure at installed height when rebuilding (a valve spring tester gives seat and open readings).
A rev limit is a valvetrain decision
The speed at which float starts depends on the spring, the moving mass, the cam's acceleration profile and the valve lift. It is only one limit on engine speed. The rotating assembly, the oil system and ring behaviour also set limits: pistons, connecting rods and rod bolts and engine oil and lubrication under load. A higher-lift cam also changes the piston-to-valve and valve-to-guide clearances, which are geometry checks: engine displacement covers the same piston-to-valve clearance logic. Set the rev limit from the weakest of those limits, and confirm any new limit on the calibration side: ECU remapping.
Sources
- Seat Pressure vs Open Pressure Explained (Valve Spring Guide). Fastime Performance, 17 March 2026 (no author listed). Seat and open pressure, float, bounce, installed height and excess pressure. A parts retailer's guidance. Accessed 2026-11-19.