Turbomook's Ford Escort Cosworth is used on the road and at the drag strip, built around a Mark Shead 2.2-litre stroker engine and a BorgWarner S300SX FMW turbo. The owner set a 700 bhp target. A MotorWorx Dyno Dynamics sheet dated 24 September 2013 shows 667.4 hp and 563.4 lb-ft in fourth gear. Escos Gaz handled the respray. Owner's introduction and bodywork photos

Engine and transmission
The engine is a Mark Shead 2.2-litre stroker engine, paired with a Primary Designs twin-scroll T4 manifold and a BorgWarner S300SX FMW turbo. Later work added an Oppliger gear kit and cradle, a Quaife thick-wall casing and an MK Motorsport rear beam. Transmission and rear beam photos
Dyno result
The MotorWorx Dyno Dynamics sheet dated 24 September 2013, photographed and posted by the owner after mapping at MAD, shows 667.4 hp and 563.4 lb-ft in fourth gear. That is below the 700 bhp target. Update after mapping at MAD

Workshop and dyno-sheet photographs from the owner's PassionFord thread, reproduced with permission.
Sources
- PassionFord build thread: introduction and bodywork photos
- PassionFord build thread: Mark Shead 2.2-litre stroker engine
- PassionFord build thread: Primary Designs twin-scroll T4 manifold
- PassionFord build thread: BorgWarner S300SX FMW turbo
- PassionFord build thread: mapping at MAD and dyno sheet
- PassionFord build thread: transmission and rear beam photos