Page organisation in this revision
- Page type
- Technical article
- Subject
- Modded Cars
- Parent
- Section level
- Applies to
- No ECU-specific applicability
- Tool groups
- None
- Manufacturers
- Ford
Changes from revision 2 to revision 3
Removed text is struck through; added text is highlighted.
This is a 2010 Mk2 Ford Focus RS500 that has run two suspension setups. The first used H&R springs and spacers with the standard wheels. The owner still wanted better damping, so Mountune fitted and aligned its Clubsport suspension.
The RS500 outside on black wheels. S1 on PassionFord, reused with permission. Source post.
Suspension and wheels
The first setup used H&R springs and spacers on the standard wheels, followed by the Mountune Clubsport suspension. A set of OZ wheels changed the offset enough to dispense with the spacers.
Exhaust and drivetrain mounts
The car has a Milltek cat-back with ceramic-black tips, Powerflex lower-arm bushes and an Elevate lower torque mount.
Roll cage
A matt-black cage is fitted. An MDF jig was made to mark where the rear legs pass through the parcel-shelf supports.
Rear view through the glass showing the cage. S1 on PassionFord, reused with permission. Source post.
Sources
PassionFord build diary: suspension, wheel and cage installation
Rendered revisions
Open each version to inspect formatting, tables and photographs.
Revision 2: S1’s 2010 Ford Focus RS500 Clubsport build
This is a 2010 Mk2 Ford Focus RS500 that has run two suspension setups. The first used H&R springs and spacers with the standard wheels. The owner still wanted better damping, so Mountune fitted and aligned its Clubsport suspension.

The RS500 outside on black wheels. S1 on PassionFord, reused with permission. Source post.
Suspension and wheels
The first setup used H&R springs and spacers on the standard wheels, followed by the Mountune Clubsport suspension. A set of OZ wheels changed the offset enough to dispense with the spacers.
Exhaust and drivetrain mounts
The car has a Milltek cat-back with ceramic-black tips, Powerflex lower-arm bushes and an Elevate lower torque mount.
Roll cage
A matt-black cage is fitted. An MDF jig was made to mark where the rear legs pass through the parcel-shelf supports.

Rear view through the glass showing the cage. S1 on PassionFord, reused with permission. Source post.
Sources
Revision 3: S1’s 2010 Ford Focus RS500 Clubsport build
This is a 2010 Mk2 Ford Focus RS500 that has run two suspension setups. The first used H&R springs and spacers with the standard wheels. The owner still wanted better damping, so Mountune fitted and aligned its Clubsport suspension.

The RS500 outside on black wheels. S1 on PassionFord, reused with permission. Source post.
Suspension and wheels
The first setup used H&R springs and spacers on the standard wheels, followed by the Mountune Clubsport suspension. A set of OZ wheels changed the offset enough to dispense with the spacers.
Exhaust and drivetrain mounts
The car has a Milltek cat-back with ceramic-black tips, Powerflex lower-arm bushes and an Elevate lower torque mount.
Roll cage
A matt-black cage is fitted. An MDF jig was made to mark where the rear legs pass through the parcel-shelf supports.

Rear view through the glass showing the cage. S1 on PassionFord, reused with permission. Source post.
Sources