Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Technical article
Subject
Modded Cars
Parent
Section level
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
Saab

This is a manual Saab 9-3 Turbo X V6 built by Lammertse Techniek. The initial setup used a G25-660 hybrid turbo, strengthened timing chains, a twin-plate clutch and MaxxECU, and was reported by the builder at 488 hp and 613 Nm on a hub dyno. A later conversion to an EFR 8374 turbo followed, and the project title refers to 700+ hp.

Lammertse Techniek Saab 9-3 Turbo X in the workshop

Photo by Lammertse Techniek, from the original project post, reused with permission.

Engine, turbo and management

The initial setup used a G25-660 hybrid turbo machined into the original housing, strengthened timing chains, a twin-plate clutch and MaxxECU. The 488 hp and 613 Nm figures are builder-reported from a hub dyno, with the original exhaust behind a 3-inch downpipe.

Exhaust

After exhaust backpressure was measured, a 3.5-inch downpipe and midpipe were built, feeding twin exhaust branches and Magnaflow mufflers.

EFR 8374 conversion

An update dated 12 January 2026 describes an EFR 8374 turbo, custom high-flow manifolds and a fuel return system. The 700+ hp in the project title is a builder's target or claim; the configuration and results at each stage are in the source post.

Sources