Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Technical article
Subject
Renault Tuning
Parent
Section level
Applies to
Sagem S3000
Tool groups
None
Manufacturers
Renault

Starting point

The Clio III RS 197 and 200 Cup use the naturally aspirated 2.0 litre F4R 832 under a Sagem S3000. The engine is already efficient as delivered, so the sensible approach is to improve airflow, keep temperatures down and treat the calibration as the finishing step. A remap on a naturally aspirated engine cannot deliver turbo-style gains; what it can do is smooth the power curve, sharpen throttle response and make other airflow work pay off. File-handling and tool notes are on Sagem S2000 and S3000 tuning tool support, and the wider family comparison is on F4R and F4RT Sagem remap expectations.

Airflow

  • Intake: a high-flow panel filter in the standard airbox is the simplest change. Aftermarket induction kits mainly change the sound, and the standard intake is described as efficient, so keeping inlet air cool matters more than a bigger pipe.
  • Exhaust: the standard system is quiet and restrictive. A freer-flowing system sharpens response and lowers back pressure. Sports catalysts or decats flow better but bring inspection and emissions problems.
  • Camshafts: in enthusiast discussion the cam profile is the single change most credited with a meaningful power gain, because it alters the inlet and exhaust durations that set where the engine makes torque.

A cam package, as claimed

K-Tec's "KTR215" package combines a high-performance camshaft, a new timing belt and a remap with a revised throttle map. The company quotes 197 bhp and 159 lb ft rising to 215 bhp and 175 lb ft for both the 197 and the 200, with torque up by 12 lb ft at 3,600 rpm, gains visible from about 2,900 rpm and the full 215 bhp arriving at 7,000 rpm. The price was £1,366.80 fitted with a 12-month, 30,000-mile warranty. No independent dyno data is given, so all figures are the maker's.

Remap-only expectations

One chiptuning reseller lists stock at 201 PS with +18 PS at stage 1 and about +25 PS at stage 2. Dyno reports from owners are much lower for software alone, in the range of 7 to 10 bhp with a panel filter, mostly at low rpm; one car with cams and a remap is reported at about 200 bhp, roughly 16 bhp over standard. Different dynos, correction factors and wheel-versus-crank figures make the numbers impossible to compare directly.

Supporting work

  • Brakes: uprated pads, high-temperature fluid and braided lines cure fade under hard use.
  • Engine mounts soften with age; stiffer mounts sharpen response but add idle vibration.
  • A short-shift kit or improved linkage tightens the gear change.
  • Bushes, ball joints and top mounts are wear items worth refreshing before spring and damper changes.
  • Tyres have a larger effect on lap time than any bolt-on power.

Not established

No like-for-like dyno data isolating intake, manifold, decat or exhaust contributions was found, and no cam specifications beyond the package above.

Sources