Page organisation in this revision
- Page type
- Technical article
- Subject
- Modded Cars
- Parent
- Section level
- Applies to
- No ECU-specific applicability
- Tool groups
- None
- Manufacturers
- Ford
Changes from revision 2 to revision 2
Removed text is struck through; added text is highlighted.
Overview
This Radiant Red Sierra Sapphire Cosworth originally put 293 bhp through a hub dyno before its clutch failed. It was fitted with an AP six-paddle clutch and later had its original 205-block engine replaced by a small-turbo Escort 200-block unit. It has been shown on the Cheshire RSOC stand at Ford Fair.
Engine and brakes
The replacement engine has a ported head, gated sump, 1,000 cc Rochester injectors and a Turbo Technics T38. Braking uses Fiat Coupé Turbo Brembo front calipers with Focus RS discs and Mintex pads.
Dyno results
The car recorded 545 bhp in an earlier run. After switching from a 4×4 exhaust manifold to a two-wheel-drive manifold and adding a plenum spacer, 542 bhp was recorded at EFI-Parts, 3 bhp lower but with 5 psi less boost. The owner reports slower response and better flow at high rpm; both figures are owner-reported. Both Ford Fair photographs are from fraser9764’s update and are reproduced with permission.
Sources
PassionFord build thread: opening post and engine swapPassionFord build thread: engine specification and brake conversionPassionFord build thread: dyno comparison, video and Ford Fair photos
Rendered revisions
Open each version to inspect formatting, tables and photographs.
Revision 2: Fraser9764’s Radiant Red Ford Sierra Sapphire Cosworth
Overview
This Radiant Red Sierra Sapphire Cosworth originally put 293 bhp through a hub dyno before its clutch failed. It was fitted with an AP six-paddle clutch and later had its original 205-block engine replaced by a small-turbo Escort 200-block unit. It has been shown on the Cheshire RSOC stand at Ford Fair.

Engine and brakes
The replacement engine has a ported head, gated sump, 1,000 cc Rochester injectors and a Turbo Technics T38. Braking uses Fiat Coupé Turbo Brembo front calipers with Focus RS discs and Mintex pads.

Dyno results
The car recorded 545 bhp in an earlier run. After switching from a 4×4 exhaust manifold to a two-wheel-drive manifold and adding a plenum spacer, 542 bhp was recorded at EFI-Parts, 3 bhp lower but with 5 psi less boost. The owner reports slower response and better flow at high rpm; both figures are owner-reported. Both Ford Fair photographs are from fraser9764’s update and are reproduced with permission.
Sources
Revision 2: Fraser9764’s Radiant Red Ford Sierra Sapphire Cosworth
Overview
This Radiant Red Sierra Sapphire Cosworth originally put 293 bhp through a hub dyno before its clutch failed. It was fitted with an AP six-paddle clutch and later had its original 205-block engine replaced by a small-turbo Escort 200-block unit. It has been shown on the Cheshire RSOC stand at Ford Fair.

Engine and brakes
The replacement engine has a ported head, gated sump, 1,000 cc Rochester injectors and a Turbo Technics T38. Braking uses Fiat Coupé Turbo Brembo front calipers with Focus RS discs and Mintex pads.

Dyno results
The car recorded 545 bhp in an earlier run. After switching from a 4×4 exhaust manifold to a two-wheel-drive manifold and adding a plenum spacer, 542 bhp was recorded at EFI-Parts, 3 bhp lower but with 5 psi less boost. The owner reports slower response and better flow at high rpm; both figures are owner-reported. Both Ford Fair photographs are from fraser9764’s update and are reproduced with permission.
Sources