Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Technical article
Subject
Reference
Parent
Section level
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
Maserati

This page collects the weak points and service items commonly associated with Biturbo-era V6 cars. The information comes from magazine features, parts-supplier listings and owner experience, so intervals and procedures must be checked against the workshop manual for the specific model.

Turbochargers and oiling

  • The twin turbos are the main expensive risk when bearings fail. Their bearings rely on engine oil for cooling and lubrication, and the mineral oils common in the 1980s tended to burn and block oil passages. Synthetic oil was rarely used at the time.
  • Check oil feed and return condition before condemning a turbo. No rebuild procedure or turbo part numbers have been confirmed.

Fuel and ignition

  • Vacuum leaks are a recurring problem on injected cars of this period. The 2.5 litre cars were carburettor-fed at first and injected later; all 2.8 litre cars are injected.
  • Later injected cars are generally regarded as the most dependable.
  • Ignition ECU faults and poor earths are the usual electrical suspects; see the fuelling and ECU page.

Timing belt, water pump and head gasket

  • Parts suppliers sell combined water pump, timing belt and tensioner bearing kits for the 18-valve engines. Listings give belt 311020349, tensioner bearing 311020107 and water pump 470045900, and note a newer pump design with a freeze plug. Confirm against the car before ordering.
  • Belt replacement is suggested at about 70,000 km in one DIY guide, while a California specialist advises a much shorter interval. These conflict, so follow the manufacturer's schedule and replace a belt of unknown age at once.
  • Head gasket replacement is a laborious job. Gasket sets for the 2.5 and 2.8 are widely available. Valve clearance is adjusted with shims.

Body and mechanical weak points (early 2.5 litre car)

  • Rear subframe cracking, mainly on early cars, and weak differentials.
  • The inlet plenum can crack if its bolts are over-tightened.
  • The low-slung finned oil sump is easily damaged.
  • Corroded connections and poor earths; rust in doors, scuttle and drain channels.
  • The starter motor is awkward to reach, and wheel bearings need regular repacking.

Diagnostics

Factory diagnostics for later cars are covered by Maserati diagnostic tools. Fault-code lists for the Weber-Marelli IAW cars, torque figures and compression specifications are not yet sourced.

Related: MABC boost control and tuning, engines.

References