This page explains how Biturbo boost is controlled and the approaches commonly used to change it. Most of the practical information comes from enthusiast experience rather than factory data, so treat it as a starting point. Raising boost without checking fuelling and ignition can destroy the engine. No dyno-verified results or ECU map values have been confirmed, so none are given.
How MABC works
- From June 1983 Maserati fitted its Automatic Boost Control (MABC): a solenoid-based system that reads inlet manifold pressure and engine speed through a pressure transducer and uses them to shape how quickly boost builds and where it peaks.
- It works through the wastegate actuators, so the wastegates open in step with boost pressure.
- The design derives from Saab's Automatic Performance Control, which was supplied to Maserati for the carburettor Biturbo and re-calibrated.
- A 2.5 litre carburettor car is described with a computer-controlled wastegate and a maximum of about 11 psi.
- Factory part diagrams for the boost control system and wastegate pipework are listed by Eurospares (part numbers only).
Common ways boost is raised
- Bleeding the wastegate lines. Letting air out of the actuator lines limits actuator travel, so boost rises. This is the simplest and most widely used method.
- Changing what MABC senses. Altering or bypassing the pressure transducer makes the controller believe boost is lower than it is, so it holds more. A bypassed transducer has been reported to give around 15 psi, roughly half as much again as standard.
- Electronic boost controller. A solenoid duty-cycle controller used with a wideband lambda sensor gives finer control and lets the mixture be watched.
- Supporting parts. Better intercooling, a blow-off valve to protect the turbos from compressor surge, uprated wastegate actuators and boost solenoids, and a revised fuel map.
- Standalone management. Systems such as Vipec or Haltech are suggested for injection cars. Carburettor cars have no engine ECU to replace. This is a suggested route, not a tested recipe.
- Catalytic converter removal. About 25 bhp is claimed on a US car, where removing it is legal.
Cautions
- Turbochargers are the main failure concern; oil supply and oil quality matter. See common faults and repair.
- On a carburettor car, more boost changes mixture and detonation margin together, and no safe settings have been sourced.
- Output differs by market and catalyst fitment, so measure a baseline power run before making changes.
Related: fuelling and ECU, engines.