Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Technical article
Subject
Reference
Parent
Section level
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
Maserati

This page collects reported problems and service items for Biturbo-era V6 cars. Sources are magazine features, parts-supplier listings and owner threads, so intervals and procedures must be checked against the workshop manual for the specific model.

Turbochargers and oiling

  • The twin turbos are reported as the main expensive risk when bearings fail. Their bearings are cooled and lubricated by engine oil, and 1980s mineral oils tended to burn and clog oil passages; few owners used synthetic (Sports Car Market).
  • Check oil feed and return condition before blaming the turbo itself. No rebuild procedure or turbo part numbers were found in sources.

Fuel and ignition

  • Fuel injection systems of the period are reported as notorious for vacuum leaks; the 2.5 litre cars were carburettor-fed at first, then injected; all 2.8 litre cars are injected.
  • Later injected cars are generally described as the most reliable (Old Cars Weekly).
  • Ignition ECU faults and bad grounds are common leads; see the fuelling and ECU page.

Timing belt, water pump and head gasket

  • Parts listings show combined water pump, timing belt and tensioner bearing kits for 18-valve engines. One listing gives belt 311020349, tensioner bearing 311020107 and water pump 470045900, and notes a newer pump design with a freeze plug (eBay listing); Eurospares lists the same belt and bearing for the 2.5 and 2.8. Check against the car before ordering.
  • A DIY guide suggests about 70,000 km for belt replacement (Autodoc), while a California specialist quoted by Old Cars Weekly recommends far shorter intervals; these conflict, so follow the manufacturer's schedule and err on the shorter side for an old belt of unknown age.
  • Head gaskets are described by owners as a laborious job, and gasket sets for the 2.5 and 2.8 are widely sold. Valve clearance is shim-adjusted.

Body and mechanical weak points (Old Cars Weekly, early 2.5 car)

  • Cracks in rear subframes, mainly on early cars; weak differentials.
  • The intake plenum can crack if its bolts are overtightened.
  • The low finned oil sump is easily damaged.
  • Corroded connections and poor grounds; rust in doors, cowl and drain channels.
  • The starter motor is hard to reach; wheel bearings need regular repacking.

Diagnostics

Factory-era diagnostics for the later cars are covered by Maserati diagnostic tools. Not yet sourced: fault-code lists for the Weber-Marelli IAW cars, torque figures and compression specifications.

Related: MABC boost control and tuning, engines.