Scope
This adds forum and vendor evidence to F4R and F4RT Sagem remap expectations for the turbocharged Megane II RS 225 and R26 (Sagem S3000). Most of it is anecdotal and several sources concern other Megane generations; where so, it is stated.
Clutch
- A Digital Kaos thread (reached only through search summary; the page itself returned 403) argues the stock clutch loses holding ability before software is the limit, while one poster reports a car on a dyno at about 280 hp with the clutch fine after 40,000 km. It is old and anecdotal.
- An RSM forum poster reports a stock clutch lasting 96,000 miles and says the dual mass flywheel is not a problem if it has not been replaced, while those who prefer a single mass flywheel are the ones who fitted one.
- K-Tec sells organic and cerametallic kits for the 225, R26 and R26.R, claiming 35% more torque holding for the organic kit. Fitment depends on the flywheel on the car, and 225, R26 and R26.R pressure plates and flywheels are not interchangeable.
- A SEAT Cupra forum poster says some remaps deliver power less aggressively so the clutch does not slip. That is another model's forum and only an anecdote.
Turbo, intercooler and fuel
- One tuning guide (fastcar.co.uk, written for the Mk3 RS250) says the stock turbo is good for around 320 bhp and the standard intercooler restricts flow as boost rises. Check applicability to the Mk2 before relying on it.
- A generic F4Rt page lists a Mitsubishi twin-scroll turbo for the F4Rt family, and cautions that the airflow sensor can restrict torque on bigger builds. It states no boost figure, and it is a generic page, not Sagem-specific.
Logged boost: nothing for the 225
The only boost data I found is an RSM forum thread on a Megane 3 RS265 (not the 225): about 1.3 bar in 4th and 5th gear on the RS Monitor and OBD, about 1 bar in normal mode, and a dyno result of 253 hp and 393 Nm at around 30 C. The poster concluded the car was unmapped. The thread says nothing about the 225 or its ECU. For the Mk2 car, the Renault service text on the S3000 page remains the only boost reference: about 1350 to 1400 mbar baseline and a stated 1800 mbar ceiling.
Claims to treat carefully
| Claim | Source type | Note |
|---|---|---|
| Stage 1: +30 bhp and +60 Nm (225 to 255 bhp, 300 to 360 Nm) | Tuner pages | Not dyno-verified |
| Stage 2: about +47 hp and +82 Nm | One chiptuning reseller | Compression ratio quoted as 9.0:1 |
| Level 1: 240 to 250 bhp, about 270 lb ft | One UK dyno shop | Depends on modifications |
| R26 build at 273 bhp and 300 lb ft (torque capped) | Forum build | Single car |
I found no confirmed turbo failures on remapped 225s and no logged boost data for the 225 on a remap. Treat those as open questions.
Sources
- Digital Kaos: Megane 2.0t 225 sagem 3000, search summary only 2026-11-19.
- RSMegane: Quick question (Megane 3 RS265), accessed 2026-11-19.
- RSMegane: 225 new clutch discussion, search summary only 2026-11-19.
- K-Tec Racing: RTS clutch kits for Megane 2RS 225 / R26, search summary 2026-11-19.
- fastcar.co.uk: Megane RS250 tuning guide, search summary only 2026-11-19.
- TorqueCars: Renault F4Rt tuning, accessed 2026-11-19.
- Chiptuningreseller: Megane 2 RS 2.0T, search summary 2026-11-19.