Cars covered
The 2.0 litre F4R engines on the Sagem S3000 include the naturally aspirated Clio III RS 197 and Megane II 2.0 16v, and the turbocharged F4R-T of the Megane II RS (225 and the 230/R26 variants). Controller background is on the S3000 page, and the tools vendors name are on Sagem S2000 and S3000 tuning tool support.
What the factory structure implies
From the Renault fault-finding text summarised on the S3000 page: the computer builds a torque setpoint from the driver, ESP and automatic gearbox requests, then derives throttle position, ignition advance and, on the turbo, the wastegate setpoint from it. On that basis, raising a power target without changing the torque limit and the boost target tables would not be expected to give more. This is an inference from the architecture, not a statement from a tuner.
On the turbo, the same text says a normally open solenoid leaves the wastegate fed with boost pressure at rest, so boost stays near the engine minimum of about 1350 to 1400 mbar. It also states a maximum of 275 Nm and 125 kW with boost never above 1800 mbar, without saying which F4R-T variant that figure belongs to. Do not read it as the RS output.
The same documents give hot rev cuts of 6000 rpm (manual F4R) and 6300 rpm (automatic F4R). A remap that raises power on an F4R still lives inside these limits unless the limiter is edited as well.
Vendor gain claims (not independent results)
| Car | Claim | Source type |
|---|---|---|
| Clio III RS 2.0 16v 197 bhp | About +14 to +15 bhp; torque 215/216 Nm to 230-236 Nm; one vendor quotes +13% torque | Tuner pages and remap statistics |
| Megane II 2.0 16v 136 bhp | About +10 bhp | UK tuner page |
| Megane II RS 2.0T 225 | Roughly 250 to 260 bhp and up to 360 Nm; stock baselines quoted as 225 to 227 bhp and 300 to 310 Nm | Tuner pages |
Baselines disagree between sellers and the figures are advertising. One dyno shop states its stage 1 aim as about 270 lb ft and 250 to 260 bhp and recommends an induction kit and exhaust. I found no independent dyno sheets, no owner-forum reports on clutch or drivetrain effects, and no source that states which torque limiters were changed.
Open questions
- Which maps hold the torque limit and boost target on the S3000, and the file layout.
- Whether the 6000 rpm cut is changed in typical stage 1 files.
- Knock margins on 95 RON fuel and the effect of heat soak on the F4R-T.
Treat these as research gaps. Do not infer them from vendor copy.
Sources
- CSC Motors: Clio RS 2.0i 16v 197hp remap stats, accessed 2026-11-19.
- Celtic Tuning: Clio III RS stage 1, accessed 2026-11-19.
- EFI Tuning: Megane 225/230/R26 dyno re-map, accessed 2026-11-19.
- AltTune: Megane RS (2nd) Sagem S3000, accessed 2026-11-19.
- ND Auto Repairs: Megane 2 2.0i 16v 136hp, accessed 2026-11-19.
- Renault MR-366 and the Megane workshop particulars, as paraphrased on the S3000 page.