Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Technical article
Subject
Modded Cars
Parent
Section level
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
Mazda

Chris, who posts as Downmented, began his turbo project with a 1995 Miata and a Fab9 side-mount manifold. After several years of development, the car reached 411 wheel horsepower on E85. Chris’s build introduction · Owner’s 411 whp summary

Chris’s dark Mazda Miata outside a workshop

Turbo and engine management

The setup used a BorgWarner EFR7163, 10.5:1 pistons, a non-VVT BP4W head and Haltech Elite 1500 management. Chris reported 25 psi from the ECU during the dyno run. He explained that the dyno boost sensor displayed 27 psi because it was not calibrated correctly. Turbo and engine specification · Dyno-day update and boost-sensor note

Blue cam cover and turbo installation in Chris’s Miata engine bay

Dyno graph from the 1995 Miata’s E85 tuning session

After tuning

In a later update Chris documented tracing an oil leak and fitting Falken Azenis RT660 tyres in 245/40 R15. Owner’s post-dyno maintenance and tyre update

Photos and dyno graph posted by Chris on Miata Turbo Forum, reproduced with permission. Car photo · Engine-bay photo · Dyno graph