Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Technical article
Subject
Modded Cars
Parent
Section level
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
Ford

Fraser’s Sapphire put 293 bhp through a hub dyno before its clutch let go. He fitted an AP six-paddle clutch and later swapped the original 205-block engine for a small-turbo Escort 200-block unit. Fraser’s opening post and engine swap

Fraser’s Radiant Red Sapphire on the Cheshire RSOC stand at Ford Fair

Engine and brakes

The replacement engine came with a ported head, gated sump, 1,000 cc Rochester injectors and a Turbo Technics T38. Fraser paired Fiat Coupé Turbo Brembo front calipers with Focus RS discs and Mintex pads. Engine specification and brake conversion

The Sapphire’s engine bay at Ford Fair

Two dyno runs

After switching from a 4×4 exhaust manifold to a two-wheel-drive manifold and adding a plenum spacer, Fraser reported 542 bhp at EFI-Parts. That was 3 bhp below the earlier 545 bhp figure, with 5 psi less boost. He described slower response and better flow at high rpm. Both Ford Fair photographs are from fraser9764’s update and are reproduced with permission. Dyno comparison, video and Ford Fair photos