Tuning Wiki

This is a historical revision. Read the current page or return to its history.

Page organisation in this revision
Page type
Technical article
Subject
Flash chips
Parent
Section level
Applies to
No ECU-specific applicability
Tool groups
None
Manufacturers
BMW, Bosch, Intel, Siemens

Intel 28F boot-block flash appears in some earlier engine controllers. It is a different programming family from the more familiar 29F devices. Identify the complete marking and the board before choosing a programmer or replacement; a similar capacity or package does not establish compatibility.

Devices and ECU examples

DeviceCapacityDocumented application or evidence
Intel 28F200BX2 Mbit (256 KiB)The MS41 recovery project identifies an AB28F200BX-B in its Siemens BMW MS41 example; an ECU list also records 28F200 for a BMW Z3 US MS41. The B suffix in that example is bottom boot. MS41 project; RTC ECU list.
Intel 28F400BX4 Mbit (512 KiB)Intel's BX datasheet specifies this 4 Mbit boot-block family. FlashOnline lists 28F400 among its supported memory types and lists several Siemens and Bosch ECUs, but does not pair every chip to every ECU. Confirm the fitted marking rather than infer it from that list. Intel datasheet; FlashOnline compatibility.
Intel 28F800F38 Mbit (1 MiB) per deviceEVC lists two 28F800F3 devices with an MPC555 in its Bosch ME9 BMW four-cylinder and V8 entry. EVC warns that data lines are exchanged on this application. Two devices have 2 MiB combined nominal capacity; the arrangement of a tool's output must still be checked. EVC BDM100 table; EVC FAQ.

28F800F3 automotive device

Intel’s preliminary automotive 28F800F3 datasheet describes an 8 Mbit ×16 fast boot-block device with synchronous burst and asynchronous page reads. Its 56-lead SSOP order codes start DE28F800F3; T and B designate top and bottom blocking. The datasheet specifies 3.0–3.6 V read and write operation and permits 12 V VPP for faster factory programming under stated cycle and exposure limits. These are chip specifications, not instructions for applying a voltage to an ECU.

A KT200 application list independently names DE28F800F3 with MPC555/6 for a BMW Bosch ME9 entry. EVC lists two devices and warns of exchanged data lines for its ME9 example. Check the exact board, direct-read ordering and tool documentation.

Programming and identification

The Intel 28F400BX datasheet specifies a 5 V supply and a separate 12 V VPP for erase and write. The MS41 project likewise identifies a 12 V programming requirement for its 28F200 example and distinguishes its Intel command set from the single-supply AMD/JEDEC 29F200 and 29F400 algorithms. These statements apply to the named parts: do not assume all 28F suffixes have the same voltage or command requirements. Consult the exact datasheet and programmer configuration before applying power.

Top- and bottom-boot versions have different block layouts. Full device capacity does not guarantee that a diagnostic read contains every block, nor that the ECU's CPU address order matches a direct chip read. The MS41 project documents address translation on its example board. Preserve the original read and record the ECU and chip markings, read method and file size before making changes.

Tool compatibility lists describe supported combinations, not a universal fitment catalogue. For example, MS4X identifies an AMD AM29F400BB on its Siemens MS43, while another service list labels some MS43 files 28F400. Treat that discrepancy as unresolved and inspect the particular ECU rather than assigning either device to every MS43.

Sources