Tuning Wiki

A vehicle speed limiter stops a vehicle accelerating beyond a set road speed by reducing the engine's fuel quantity or torque request, whatever the accelerator position. The same function is used for four different purposes: a manufacturer's top-speed cap, a legally required limit on goods vehicles and buses, a limit the driver sets and can override, and a fleet or special-purpose restriction.

The purposes differ in status. A car maker's top-speed limit is a calibration value chosen by the manufacturer. The limiter on a heavy goods vehicle or bus is required by law, set to a prescribed speed and sealed against adjustment. The explanation here covers how limiters work and what depends on them, not how to alter one.

Types of limiter

Manufacturer top-speed limits

Many German cars are electronically limited to 250 km/h (155 mph) under an informal agreement between manufacturers, not a law. The best-supported origin is 1987, when BMW limited its V12 750i to head off political pressure for an autobahn speed limit; Mercedes-Benz, Audi and others followed and Porsche did not (Automotive News Europe, reported in 2005). A 2026 enthusiast-press account dates it to the 1970s without giving a year. The 1987 account is more specific and nearer in time, so it is the better-supported date. Factory options have raised the limit on some models since at least 2005.

Volvo limited every new car to 180 km/h from 2020 as policy (fleet trade press). A limit can also follow the tyres: some manufacturers fit a governor when a vehicle is ordered with tyres rated below its unrestricted top speed (Wikipedia, tyre code article).

Legally mandated limiters

Council Directive 92/6/EEC required speed limitation devices on the heaviest vehicles: buses and coaches of category M3 over 10 tonnes set at 100 km/h, and goods vehicles of category N3 set so that they cannot exceed 90 km/h. Directive 2002/85/EC extended this to all vehicles of categories M2, M3, N2 and N3, which covers passenger vehicles with more than eight passenger seats and goods vehicles over 3.5 tonnes. The limits remain 100 and 90 km/h, and the newly covered classes apply to vehicles registered from 1 January 2005. The devices must be installed by workshops or bodies approved by the member state.

In Great Britain the rules are in regulations 36A and 36B of the Road Vehicles (Construction and Use) Regulations 1986. As published on legislation.gov.uk:

VehicleFirst usedLimiter setting
Goods vehicle over 3,500 kg up to 12,000 kgOn or after 1 January 200590 km/h (56 mph)
Goods vehicle over 12,000 kgOn or after 1 January 198890 km/h
Bus (several weight and date bands)On or after 1 January 1988, extended to lighter buses from 2005100 km/h (62 mph)

Some older goods vehicles and coaches keep earlier settings of 60 mph and 112.65 km/h (70 mph). GOV.UK summarises the scope as vehicles with more than eight passenger seats and goods vehicles over 3.5 tonnes maximum laden weight.

Driver-set limiters

UN Regulation No 89 defines the adjustable speed limitation function fitted to cars and vans. The driver chooses the limit in steps of no more than 10 km/h from 30 km/h upwards, and the function can be switched on and off at any time. The limit may be exceeded only by a positive action, for which the regulation's example is pressing the accelerator fully down, and the driver is warned while above it. Bosch describes release by the control lever or the kick-down switch.

Intelligent speed assistance

Regulation (EU) 2019/2144 requires intelligent speed assistance (ISA), defined as a system that helps the driver keep to the appropriate speed by giving feedback. It applies to new vehicle types from 6 July 2022 and to all new registrations from 7 July 2024. ISA is not a fixed limiter. The driver must be able to switch it off, it returns to normal operation at each start, and it must not affect "the possibility, for the drivers, of exceeding the system's prompted vehicle speed". Permitted feedback ranges from acoustic or vibrating warnings to a speed control function that the driver overrides by pressing the pedal further (European Commission). The retained version of the regulation was revoked in Great Britain on 31 December 2022.

Fleet and special-purpose limits

Bosch notes that special vehicles can offer a range of fixed, programmed limits, such as a refuse truck with crew on the rear platform. Manufacturer-fitted limiters on vans that are not legally required to have one, at settings such as 56, 62, 68 or 70 mph, are described in Wikipedia's speed limiter article without a citation.

How the ECU implements a limit

The limiter needs a road-speed signal, which Bosch shows as an ECU input that can also arrive over CAN. On networked cars, wheel speeds are broadcast by the ABS/ESP controller, as Audi's 2004 A3 gearbox document shows for the driveline CAN bus.

In Bosch's description of electronic diesel control, the limiter holds the injected fuel quantity to a limit consistent with the selected maximum speed. In torque-structured systems from EDC16 onwards, the limiter, the accelerator pedal and cruise control are all processed as requests for propulsion torque, and the limiter's request is the one delivered once the set speed is reached. UN R89 defines the function the same way, as control of the engine's fuel feed or engine management, and forbids a mandated limiter from applying the service brake. A petrol torque-structured ECU turns torque requests into an air charge instead of a diesel fuel quantity, as outlined in pedal response and surge damping.

The intervention is progressive. R89's approval test requires the vehicle to settle at the set speed with no more than 5% overshoot and a rate of change of speed no greater than 0.5 m/s², then to hold within the greater of 4% or 2 km/h with no more than 0.2 m/s².

Speed limiter or rev limiter in a log

Both limits stop acceleration with the pedal down. A speed limiter shows road speed levelling at the same value in every gear tall enough to reach it, with engine speed below its maximum and the torque request or injected quantity falling while pedal position stays high. A rev limit shows engine speed levelling at the same value in every gear, at whatever road speed that gives. Bosch's maximum-rpm control also ramps fuel down, so the fuel trace alone does not separate them. The channel that stopped rising, road speed or engine speed, does. See rev limiters and torque requests and the limit that wins.

What a raised or removed limit exposes

  • Tyres. The speed symbol is the maximum speed at which the tyre can carry its rated load: for example T 190 km/h, H 210, V 240, W 270 and Y 300 km/h. V, W and Y tyres additionally require load reductions above 210, 240 and 270 km/h respectively.
  • Propshaft critical speed. A driveshaft has a speed at which whirling coincides with its natural frequency and vibration is amplified, to the point where the shaft may destroy itself, and longer shafts have lower critical speeds (driveshaft maker's technical page).
  • Brakes. The 1992 directive's own reasoning is that engine power sized for climbing gradients allows speeds on the level that are not compatible with other components such as brakes and tyres.
  • Aerodynamics and gearing. Power demand rises with the cube of speed, so removing a limit raises top speed only as far as the power and the gearing allow. See aerodynamic drag and the power needed for speed.
  • Insurance. UK consumer guidance states that a remap must be declared as a modification and that failing to do so can invalidate cover. It does not address limiter changes specifically.

Legal position

Mandated limiters are legal equipment. UN R89 requires that the limit threshold cannot be raised or removed on vehicles in use, and that the function and its connections are protected by seals or the need for special tools. The British regulations require the limiter to be sealed by an authorised sealer, a person or firm authorised by the Secretary of State, who must confirm the limiter meets the regulation and supply a plate. A vehicle may complete the journey on which its limiter failed and be driven for repair, and emergency-service and military vehicles are exempt. GOV.UK directs operators to approved speed limiter centres for testing and repair.

A manufacturer's voluntary top-speed limit on a car is not legal equipment of this kind, but changing it is a modification with the consequences above. See also ECU remapping.

Not established

  • No primary document for the 250 km/h agreement has been identified. Its date and parties rest on press reports.
  • Factory or dealer-set limits on vans are not documented in a manufacturer source cited here.
  • Whether British approved speed limiter centres and approved tachograph centres are the same approved bodies is not stated on the GOV.UK pages cited.

Sources