VehiCAL is calibration software for logging and for changing a supported calibration while the engine is running. It is not a map editor. The publisher says the logger can record from master and slave engine computers, a transmission computer and a CPC at the same time, that an A2L file is not required, and that it works with a J2534 interface. It also describes WinOLS integration and reading and clearing fault codes. Access is pay as you go, with a separate Pro arrangement for a dealer network.
Live tuning is described as part of the logger for most Bosch MED17, EDC17, MG1 and MD1 units the logger already supports. The publisher says the control unit has to be patched first, in boot or by a tool that can perform a full write over OBD. Changes made live are held in calibration RAM and are lost when the ignition is cycled, until a normal flash stores them. The patch and the flash are done with a programming tool, not by VehiCAL alone. Any editor that can save the binary can be used. The publisher is AutoTuner OÜ in Tallinn.