Tuning Wiki

Torque describes twisting effort at a shaft. Power describes how quickly that shaft does work: it depends on both torque and rotational speed. Fuel flow describes how much fuel the engine consumes per unit time; brake-specific fuel consumption (BSFC) relates that flow to brake power.

Torque and power

At a steady operating point, power is torque multiplied by angular speed. In common units:

Power (kW) = torque (N·m) × engine speed (rpm) / 9,549
Power (mechanical hp) = torque (lb-ft) × engine speed (rpm) / 5,252

The constants are rounded. The numerical crossing at about 5,252 rpm applies only when plotting mechanical horsepower and pound-feet on matching numerical scales; it does not mean that power and torque are the same physical quantity. A US Department of Energy engine test report uses the horsepower relationship.

An engine can make less torque per revolution at higher speed yet produce more power because it turns more times each second. Peak power and peak torque therefore need not occur at the same speed. Compare curves over the range used by the vehicle rather than selecting a calibration solely from one peak.

Measured and estimated torque

Some engine controllers calculate an estimated torque from operating data and a model; that value is not necessarily a physical torque-sensor reading. Bosch ME7 is one documented example of model-based torque control. A dyno can instead measure a reaction force or shaft torque at its specified measurement boundary.

Direct shaft-torque sensors are also used in testing and some powertrain applications. For example, Methode describes a magnetoelastic flexplate sensor for measuring engine-output torque. ABB describes its Torductor 500 for marine propeller-shaft torque and power; that is a separate application, not evidence that a particular car has this sensor. A measurement at an engine output, gearbox input, hub or roller represents a different boundary. Identify location, calibration and sample rate before comparing it with an ECU estimate or another measurement.

Fuel flow and BSFC

BSFC is fuel mass flow divided by brake power, typically expressed in grams per kilowatt-hour. Lower BSFC means less fuel mass for each unit of measured brake work at that operating point. It is distinct from fuel mass per injection event and from vehicle fuel consumption, which also depends on gearing, road load, driving and drivetrain losses.

The US EPA's engine fuel-consumption study presents BSFC against engine speed and torque for specific test engines. Such maps show that efficiency changes across the operating range; the most efficient point, maximum torque, maximum power and highest fuel flow are separate measurements and should not be assumed to coincide.

Steady-state and sweep tests

A load-controlled dynamometer can hold a selected operating point so an operator can observe torque and other channels while conditions settle. A sweep records behaviour as speed changes through a range; its result depends on the test setup and operating conditions. The two answer different questions, and not every dynamometer supports both modes. Dynojet's load-test documentation describes steady-state and step testing for its equipment.

Allow for sensor and exhaust transport delay when comparing lambda with engine speed and load during a sweep. Dynojet provides a configurable offset for that purpose in one tuning workflow; its example offsets are equipment-specific. Monitor temperatures and allow suitable recovery between runs. Cooling airflow and exhaust extraction are part of the test setup, as described in the manufacturer's dyno-room guidance.

Interpreting a dyno comparison

  • Identify whether the result is measured at the engine or wheels, the units, speed range, gear and any correction applied. Wheel and crank figures are not directly interchangeable.
  • Compare repeatable runs with the same setup, fuel and operating conditions as closely as practical. Record intake temperature, pressure and the calibration as well as the result.
  • Check mixture, fuel pressure, ignition and temperatures alongside torque. A higher peak alone does not establish that the whole operating range or durability has improved.

See mixture tuning, logging and intake manifold tuning.