A single-mass flywheel (SMF) is a substantially rigid rotating flywheel. A dual-mass flywheel (DMF) divides the assembly into two masses joined by a torsional spring-and-damper system. The correct comparison includes the clutch and the rest of the driveline, not the flywheel in isolation. Schaeffler: DMF design.
Single-mass flywheels
A typical manual SMF bolts to the crankshaft, provides a friction surface for the clutch disc and supports the clutch cover. It may carry a starter ring gear and, depending on the engine, a separate speed or position sensor target. Many compatible clutch discs have sprung hubs that provide torsional damping, but a sprung disc is not present in every design. A rigid flywheel can be factory equipment or part of an engineered conversion.
Dual-mass flywheels
In a common design the primary mass attaches to the crankshaft and the secondary mass connects to the transmission through the clutch. Bearings support their relative movement, while internal springs and friction elements control the twist between them. Other constructions and transmission interfaces exist. The springs and damping help isolate the gearbox from changing engine torque and can reduce gear rattle and low-speed vibration. Schaeffler: vibration, components and function.
A DMF's secondary-side inertia and its compliant coupling change the torsional behaviour of the whole system. It is designed to control vibration across the intended operating range, including by moving a resonance away from normal running where the design permits. It does not eliminate every vibration, and a simple mass comparison does not describe the damping.
The clutch design and its damping are part of the complete assembly. See clutch types and operation for the disc, pressure plate and release system.
Choosing and identifying the arrangement
Both petrol and diesel vehicles may use either arrangement. Some dual-clutch transmissions use a DMF, and other automatic layouts can incorporate torsional dampers. Identify the original assembly by vehicle identification, engine and gearbox code, part number and manufacturer catalogue; do not infer it from fuel type or the presence of an automatic gearbox alone. See flexplates and dual-clutch flywheels for examples.
A DMF normally has some permitted relative movement, but the acceptable movement, condition and test procedure vary by design. Some surface grease traces may be normal on particular models. Use the maker's application-specific assessment, not a universal number of teeth or an assumed rule that any play means failure. Schaeffler: assessment and permissible conditions.
Continue with conversion considerations, fault diagnosis or the flywheel overview.