Škoda Self-Study Programme 27 identifies Simos 3PB on its 1.4-litre, 44 kW AMD Octavia example. It describes sequential petrol injection, electronically controlled throttle and cylinder-selective knock control. The accompanying English rendering and the separate Octavia Simos 3PB workshop procedure provide examples of diagnosis. These are specific to this engine and system, not a general definition for all Simos 3 vehicles. Read the actual ECU identification and use current vehicle-specific workshop information.
Load and throttle signals
In this training example, engine speed and intake-manifold pressure are used to determine load for the injection and ignition calculation. The combined intake pressure and temperature sensors are G71 and G72, and J338 is the electronic throttle control unit. The programme describes a substitute strategy based on throttle position and engine speed when the relevant pressure signal is missing, and a coolant-temperature-based substitute if intake-air temperature is missing. An apparently plausible reported value during a fault can therefore be substituted rather than measured. Check fault status and the exact diagnostic channel before treating a value as proof of the sensor or changing an air or fuel calibration.
Crank and cam signals affect knock interpretation
SSP 27 describes crankshaft speed sender G28 and camshaft position sender G163 being used together for cylinder synchronisation. It says loss of G28 can stop a running engine, which can then be restarted in an emergency programme using G163. If G163 fails, it describes continued operation on G28 with knock control switched off and ignition angle retarded. The workshop procedure identifies G163 with the Hall sender G40 and also describes continued running and restart without its signal. These are the documented 3PB example's fallback behaviours; they do not establish the same response for every Simos suffix or every fault. A running engine or a zero knock correction cannot by itself establish that cylinder-selective knock control is operating.
Record fault codes and conditions before clearing them. If cam or crank synchronisation is implausible, follow the specific workshop procedure for sensor signals, wiring and mechanical timing before changing ignition maps. The manual's G163 check and its separate G61 knock-sensor procedure distinguish sensor and circuit checks from calibration work.
Workshop displays and log comparison
The reproduced 1.4-litre Simos 3PB display-group overview identifies group 011 as actual ignition angle with engine speed and temperatures. It labels group 020 as individual-cylinder ignition-angle correction from knock control, group 026 as cylinder-associated knock-sensor voltage signals, and group 028 as a knock-sensor test result. The four cylinder-associated voltage displays do not establish that four separate knock sensors are fitted: the same engine's component overview identifies G61. Voltage is not a direct, universally comparable measure of knock severity or a tuning target.
The same overview lists group 030 lambda-probe status, group 031 probe voltage and group 033 lambda-control value. Interpret these with the manual's stated operating conditions, channel definitions and current specifications. For repeatable comparisons record fuel, engine speed, load, temperature and fault status; verify channel sampling and units. Investigate a mechanical, sensor, intake or fuel-system fault before modifying injection or ignition, and retain knock control. The cited sources do not identify performance-map addresses, scaling or safe numerical tuning changes.
Sources
- Škoda SSP 27, Octavia 1.4-litre engine and gearbox 002, pages 4, 10–17 and 29–30, German edition; English rendering. Factory training information on the AMD Simos 3PB example and fallback strategies.
- Škoda Octavia Mk1 workshop manual: Simos 3PB display groups 011–055; component overview, G163 check and G61 check. Reproduced workshop information. Accessed 17 November 2026.