Tuning Wiki
Browse Škoda
Applies to

Check the hardware and software limits stated in this article.

This guide describes the Škoda Octavia Mk1 1.6-litre, 74 kW Simos 2 workshop measuring-block examples. The engine, ECU and diagnostic tool must be identified before using the group or field numbers; they are not universal Simos definitions or performance-map addresses.

Lambda control status and learned values

In the workshop's lambda functional check, group 001 displays coolant temperature and lambda-probe voltage; the procedure proceeds only with coolant at least 80 °C. It then uses group 099 field 4 for control status. The status identifies, among other things, probe readiness, whether lambda control is switched on, whether the controller is at its stop, and the probe's rich/lean indication. The manual describes checking the heater when the probe voltage fluctuates more slowly than its specified rate. Use the original procedure and appropriate equipment, not those observations as a substitute for diagnosis.

When the controller is at its limit, the probe indication and the direction of controller correction describe different things. The manual's example says a sustained lean indication can coexist with a controller at the enrichment stop, while a sustained rich indication can coexist with a controller at the leaning stop. That is feedback about this control system; it does not prove the injector, sensor, air leak or fuel supply is the cause. Confirm status, channel identity and conditions, then follow the vehicle-specific diagnostic checks.

Group 011 displays the idle lambda learned value in field 2 as an additive time and the partial-load learned value in field 3 as a factor. The manual interprets a positive idle correction or a partial-load factor above one as lengthening injection relative to the basic calculation; a negative idle value or factor below one represents shortening it. They have different units and cannot be compared as if both were percentages. Read the values with the specified conditions, verify the tester's display and consult current limits. An adaptation shows compensation and operating history, not an independent measurement of delivered fuel or proof that a fuel map needs editing.

Cold-start interpretation

The manual's cold-start check compares symptoms before and after lambda control becomes active. It notes that probe temperature, ambient temperature, operation after starting and heater function affect the transition. If symptoms change after control starts, the timing can guide investigation, but it does not isolate a failed part. Record starting conditions and fault memory before resetting adaptations. A passenger should operate a diagnostic tester during any road test.

Knock-related displays

The same measuring-block overview describes group 014 as cylinder-specific ignition-angle retard through knock control during normal driving; groups 015 and 016 pair engine speed and air mass with two cylinders' corrections. The manual states that group 014 displays zero at idle. It lists several possible explanations for unusually high common corrections or a cylinder differing from the others, including sensor connection or mounting, loose parts, fuel quality and engine condition. Those patterns direct checks; they do not prove audible knock, identify a defective component or establish a safe amount of ignition advance.

For comparable runs, record fuel, temperature, engine speed, load, faults and any relevant maintenance. Verify the selected group, units, sample rate and logger support; a zero value at idle or no sampled correction does not prove there was no knock at other operating points. Investigate mechanical and sensor faults before considering ignition or mixture changes, and retain knock control.

Sources and scope