Valve lift and camshaft phase are different controls. On the documented SEAT 1.8 TSI, the SEAT Simos 12 training programme 158 describes Valvelift as an exhaust-valve lift changeover. Audi eSelf-Study Programme 920243 identifies another set of Simos 12 engines with different equipment. These are installation-specific examples: the ECU family, displacement or a map name alone does not prove a particular cam system is fitted.
SEAT 1.8 TSI example
SEAT describes axial movement of exhaust-cam carriers to change exhaust-valve opening. The control unit uses engine speed G28, accelerator module GX2 and coolant temperature G62 to determine when to switch, then briefly energises camshaft setting variator actuators F366–F373. The rods engage the carrier guide grooves and return mechanically after the switch. SEAT says the control unit senses a voltage peak associated with that return. This is a description of the documented system's switching and feedback, not an instruction to trigger an actuator manually or a universal diagnostic test. See SSP 158, page 17.
Different equipment in the Audi examples
Audi's 2013 programme lists its North American CNSB 1.8 TFSI example with Simos 12, continuous intake cam adjustment, no continuous exhaust cam adjustment and no exhaust Audi valvelift. Its CNTA and CYFB 2.0 examples are listed with Simos 12, continuous adjustment of both camshafts and exhaust valvelift. The manual says the 2.0 system uses exhaust camshaft lift switching; it identifies F366–F373 as cam adjustment actuators and N318 separately as the exhaust camshaft adjustment valve. Audi's initial North American examples are direct-injection only. The tables describe those specified examples at publication, not every 1.8 or 2.0 EA888.
The SEAT 1.8 example and Audi CNSB show why engine size alone is insufficient to infer Valvelift. Likewise, exhaust cam phasing and lift switching should not be treated as one command or a single component. Audi says its 2.0 Valvelift was initially fitted even though those North American engines did not use the dual-injection system; lift hardware alone does not prove intake-port injectors are installed.
Using this distinction in a tuning log
- Identify the engine, ECU hardware and software, installed actuator hardware, fuel system, modifications and fault history. Check current vehicle-specific workshop data.
- Where the actual ECU and logger define them, compare intake and exhaust cam phase requests and feedback separately from valve-lift request, status or fault information. Confirm units, bank or cylinder assignment and whether each channel is commanded, measured or inferred. A displayed state does not independently prove each cam carrier moved.
- Compare repeatable rpm, load, coolant temperature and operating conditions around a change in behaviour. A missed or unexpected transition, a phase mismatch or a power change alone does not prove a calibration fault. Follow the applicable guided diagnostic test for actuator, wiring, sensor and mechanical issues before changing a map.
- Confirm the exact map definition and its mode selection before editing. The separately indexed Simos 12.2 C30 A2L ignition reference contains valve-lift-related labels, but its source and match to an ECU remain unverified. Those labels do not prove installed hardware, active map selection or safe timing values.
Do not copy switching points, phase limits or ignition settings between these applications based on family naming. Establish the actual control and baseline first; the training documents do not provide a tuning recipe or validated map addresses.
Sources
- SEAT Self-Study Programme 158, 1.8 TSI third generation, Continental Simos 12, Valvelift section, page 17. Factory training source for the 1.8 example; accessed 17 November 2026.
- Audi eSelf-Study Programme 920243, 1.8L and 2.0L Third Generation EA888 Engines, pages 7–9, 18–20 and 63. North American example equipment, actuator and valvelift description; accessed 17 November 2026.