This 1988 Mazda RX-7 Turbo II has had two very different turbocharged engines. It first made an owner-reported 539 wheel horsepower at 25.5 psi from a 13B rotary, then was rebuilt with a twin-turbo 5.3-litre V8, later paired with a BMW M5 dual-clutch gearbox.
13B rotary setup
The rotary used late Series 5 Turbo II irons, a large intake street port and a BorgWarner EFR 9180 on a Turblown manifold. Four 2,200 cc injectors and an MS3X ECU supplied and controlled the engine. A water-to-air intercooler and water injection supported the setup. The owner reported 407 lb-ft at the wheels, and clarified that the dyno run used 93-octane petrol and water injection (owner-reported dyno result).

Twin-turbo V8 and gearbox
The later aluminium 5.3-litre LC9 uses twin EFR 6758 turbos, a cam and valve springs. The owner reported 716 whp at 18 psi with a T56 manual gearbox (owner-reported). The subsequent BMW F10 M5 dual-clutch conversion used a Domiworks adapter and HTG transmission controller, with MaxxECU engine management. The dual-clutch update describes a lower 8 psi setting, so the 716 whp result belongs to the earlier T56 configuration.


Photographs posted by Shainiac, reproduced with permission.