Summary
Sagem S2000 and S3000 calibration files are edited in WinOLS using EVC’s OLS283 checksum plugin and bought-in definition packs. Several file lengths and sub-variants exist under the “S2000” and “S3000” names, so a file must be identified by its own software number rather than by the car. The checksum addresses, map addresses and scalings are not publicly documented. Tool coverage is on Sagem S2000 and S3000 tuning tool support.
Checksum correction: OLS283
OLS283 is listed for “Sagem 2000 / 3000” and also covers several Valeo families. The plugin has one checksum point and targets WinOLS 5, and WinOLS 4 checksums stopped being updated after 31 December 2022. Its changelog shows how the Sagem family has been extended:
- January 2005 (v1.5): new address for the SPI string in Sagem 3000.
- June 2011 (v2.16): Sagem 3000 with 1FF00h length added.
- November 2012 (v2.21): better recognition for S2000PM2.
- May 2015 (v2.24): Sagem 3000 files with 10000h length added.
- May 2023 (v2.34): S2000PL4FC5 with 90000h length added.
This indicates that several file lengths and sub-variants exist; it is not a list of supported cars, and the plugin page gives no ECU list.
Definition packs
Sellers supply S2000 definitions as DAMOS, Super Mappack or OLS map packs, converted from A2L files. One listing ties an S2000 DAMOS to a Clio III 1.6 16v with ECU number RDGL40, and another reseller advertises Renault DAMOS for WinOLS covering both S2000 and S3000. These are sales descriptions; no pack has been examined, so map labelling and axis accuracy are unknown.
A documented S3000 file
A file marketplace listing for a 2007 Megane RS 2.0 turbo (stock quoted as 221 PS) gives these seller-stated details:
- ECU numbers 8200509963 (product) and 8200752572 (ECU), Sagem 3000.
- A complete binary of 65,536 bytes, bench-read with Alientech Kess V2.
- Checksum shown as correct in OLS283 v2.34, with the 8-bit sum at 0000.
- Claimed content: higher boost and ignition advance, speed limiter removal, catalyst monitoring and post-cat oxygen sensor faults disabled, and an E85 option with adaptive fuelling, cold-start enrichment and knock control, sold for competition or off-road use only.
The 65,536-byte length is a useful check when comparing a read with a file. The E85 and emissions claims are untested; see E85 on Renault Sagem ECUs. Emissions-system deletions are illegal for road use in many places.
Replacement and cloning
A 2015 forum case of a 2007 Megane 2.0 16v convertible with a failed S3000 reports that a replacement ECU fitted with the original EEPROM started but ran erratically with a throttle track fault, and that cloning the serial flash was suggested instead. The thread does not name a programmer or chip and does not record an outcome. It is consistent with the Renault text on the S3000 page that a replacement computer needs its immobiliser procedure, but it does not prove it.
Not established
- Which sub-variants correspond to which file length.
- Checksum addresses, and what the SPI string holds.
- Map addresses, scalings and the tables holding torque and boost targets.
- Whether the S3000 flash is read in the same way across all years.
Sources
- EVC: OLS283 checksum plugin, accessed 2026-11-19.
- DAMOS-World: Sagem S2000 files, accessed 2026-11-19.
- AutoDTC: Renault DAMOS for WinOLS, via search summary 2026-11-19.
- BinUnlock: Megane RS Stage 2 listing, SW 8200752572, accessed 2026-11-19.
- ECUEdit: Sagem S3000 recovering ECU thread, accessed 2026-11-19.