Scope and evidence
This page extends Clio III RS 197 and 200 tuning guide and the Clio II RS remap notes. The camshaft data below was seen only through search summaries of vendor pages (the product pages themselves returned access errors) and one extract of a manufacturer sheet whose table was garbled, so the figures need confirming with the supplier before purchase.
Profiles listed
| Cam | Fitment | Listed figures |
|---|---|---|
| Cat Cams road cam (F4R 730) | Clio II RS 172 and 182 (F4R 730) | Opening 272 and 256 degrees at 0.1 mm; lift 11.30 and 10.25 mm; uses standard valve springs and retainers |
| Cat Cams 276 degree | Clio II RS 16S | Listed, other figures not retrieved |
| Cat Cams 300/293 degree and 278/269, 242/234 pairs | Clio III RS 2.0 | Listed, other figures not retrieved |
| Cat Cams finger followers | F4R | Launched for high-rpm use |
| Piper F4R range | 172, 182 and 197 listed | Duration and lift table present in the maker's sheet but unreadable in the extraction; Piper states full lift is at the midpoint and the correct full-lift position is given on its timing sheet |
Fitting and set-up notes
- One owner discussion says the 197 cams have their own specific timing when used in a 172 or 182, can be fitted on standard timing, but are preferred for competition or track use. That is opinion, not a manufacturer specification.
- For one Cat Cams profile an owner quotes valve lift at TDC of 0.65 mm for the inlet (variable valve timing disengaged) and 1.75 mm for the exhaust; use the timing card supplied with the actual cam.
- Cat Cams sells fully adjustable, lockable vernier pulleys for the Clio II RS (a variable-valve-timing delete), which also affects how the ECU's cam phasing is handled.
- Nothing was found on belt tensioning or interval after a cam swap, on spring part numbers for a fast-road build beyond "standard springs for the road cam", or on how far the Siemens Sirius calibration must be altered (see ECU tuning guide).
Reading the evidence
A road cam that keeps standard springs and idle quality is the low-risk route and is the part of the K-Tec 215 bhp package described for the 197 and 200. More aggressive grinds need valvetrain work and a tailored calibration, and none of the sources gives independent dyno evidence for a specific cam on a 172 or 182.
Sources
- Oreca Store: Cat Cams 272 camshaft for F4R 730 Clio II RS, via search summary 2026-11-19.
- GT2i: Cat Cams 276 degree for Clio 2 RS 16S, search summary only (page returned 403) 2026-11-19.
- GT2i: Cat Cams for Clio 3 RS 2.0, search summary only (page returned 403) 2026-11-19.
- Piper Cams: Renault page (F4R), via search summary (table garbled) 2026-11-19.
- K-Tec Racing: Cat Cams Clio 2 RS performance camshafts, via search summary 2026-11-19.
- ClioSport: group N cam timing, via search summary 2026-11-19.