Tuning Wiki
Browse Renault

The engine

The Clio V6 Phase 2 (255 PS) uses the 3.0 litre L7X, listed as 2,946 cc (87.0 x 82.6 mm) with an 11.4:1 compression ratio and 255 PS (about 252 bhp) and 300 Nm. The car is a mid-engined sibling of the Clio II RS 172 and 182 and shares Clio generation context with Renault Clio: generations and engines. One discussion notes that the earlier 230 and the 255 differ and that the first car's output was held back, but the details were not confirmed.

Quoted remap gains

ClaimSource type
Stage 1 file to 273 hp and 323 Nm (+18 hp, +23 Nm)Tuner
About 270 hp and 320 NmChiptune vendor
Byteflash: 270 bhp and 320 Nm (+15 bhp, +20 Nm), no hardware changesTuning file vendor
+16 hp and +21 Nm, with a "roughly 10%" statement on the same pageReseller database page labelled as a demo

Owner discussion is sceptical: contributors argue that a naturally aspirated engine will not give +20 bhp from software alone and that dyno before-and-after runs are the only way to see a real figure. The reseller's own page contradicts itself on the percentage, and the vendors' numbers are sales claims.

Intake and exhaust

A generic tuning reference says intake and exhaust changes alone usually add no power and mainly pay off once other changes create a flow demand. That advice is not V6-specific. No V6 dyno data isolating induction, manifold or exhaust contributions was found.

Not documented

The ECU model and read method (one discussion mentions Bosch units being supported by a tuner, with no variant given), the stock rev limit and any raised limit, and independent dyno results. The only rev-limit reference located belonged to another car and has been disregarded.

Sources