RaceTCS V3 connector positions from the version 1.04 manual, page 9. Numbers denote rows and letters columns as drawn by the maker; letters skip I. Both early and later diagrams show these functions but differ in displayed colours, so identify cavities rather than relying on wire colours. This is not the V2 pinout.
Injector/coil inputs and outputs refer to the selected fuel-cut or spark-cut configuration; check the applicable operating mode and manufacturer requirements.
| Pin | Function |
|---|---|
| 1A, 1B, 2A, 2B | Ground |
| 1L, 1M | Power ground |
| 4L, 4M | Switched ignition +12 V |
| 4A, 4B | +5 V output |
| 3A | Preset potentiometer input |
| 3B | USB ground |
| 3C | USB D− |
| 3D | USB D+ |
| 3E | USB Vbus |
| 3G | Front left wheel-speed input |
| 3H | Front right wheel-speed input |
| 3J | Rear left wheel-speed input |
| 3K | Rear right wheel-speed input |
| 4H | Clutch input |
| 4J | LED output |
| 4K | 0–5 V output |
| 1C | Injector/coil output 8 |
| 1D | Injector/coil output 7 |
| 1E | Injector/coil output 6 |
| 1F | Injector/coil output 5 |
| 1G | Injector/coil output 4 |
| 1H | Injector/coil output 3 |
| 1J | Injector/coil output 2 |
| 1K | Injector/coil output 1 |
| 2C | Injector/coil input 8 |
| 2D | Injector/coil input 7 |
| 2E | Injector/coil input 6 |
| 2F | Injector/coil input 5 |
| 2G | Injector/coil input 4 |
| 2H | Injector/coil input 3 |
| 2J | Injector/coil input 2 |
| 2K | Injector/coil input 1 |
Source: RaceTCS V3 user manual. Confirm orientation, actual harness revision, vehicle-specific wiring and compatibility against the manufacturer’s drawing before installation.