Porsche's 992-generation 911 range includes different Porsche Doppelkupplung (PDK) transmissions. In the documents below, Carrera, Targa and Turbo examples use specified eight-speed G1F or G1G PDKs, while the GT3 example uses a seven-speed G1C PDK. A 911 badge or a PDK fault code is not sufficient to establish the gearbox or applicable procedure. Identify the model, year, market, transmission, controller software and previous programming or calibration. Sources: Porsche SY 185/23, TI 08/23.
Unexpected Park after stop-start: eight-speed
Porsche SY 185/23 describes a complaint on listed 2020–23 model-year 992 Carrera, Targa and Turbo applications with the eight-speed G1F/G1G PDK: the car selects Park during start-stop operation. Porsche attributes the documented case to internal transmission-controller communication and lists programming as the historical remedy. Establish the actual conditions, gearbox and software and follow current Porsche guided diagnosis; an unexpected Park selection does not by itself prove this software condition or identify the repair for another model.
Manual first-to-second request: eight-speed Turbo
For specified 2020–22 992 Turbo and Turbo S cars with the eight-speed G1G PDK, Porsche's updated SY 24/23, release 3 describes an early low-load first-to-second paddle request that may not be carried out in manual mode, while automatic-mode shifting works normally. The bulletin associates the documented condition with the controller's transition from drive-off to driving mode and lists a software remedy. Match model, market, production and controller version; a missed paddle request can have other causes and does not establish this condition on a GT3 or another PDK.
Clutch activation code after calibration: seven-speed GT3
Porsche TI 08/23 addresses a P081000 clutch-activation malfunction stored after PDK calibration on specified 2021–23 992 GT3 and GT3 Touring cars with the seven-speed G1C transmission. Its historical action is controller programming with the specified Porsche diagnostic equipment. Record the code, calibration history and vehicle software and consult current service information before a repair; P081000 in another situation is not proof of the same software issue or an automatic instruction to program.
Permanent fault-memory entries: wider Porsche example
For listed 2012–22 Porsche vehicles including specified 911 991/992, Panamera, Cayman/Boxster and 918 applications in the US, Puerto Rico and Canada, Porsche TI 09/26 describes permanently stored P1775, P071400 or P184900 entries that cannot be deleted because of a PDK controller software issue. Porsche says component replacement will not resolve the specific fault type described and identifies programming as its remedy. Capture the complete code and description, identify the vehicle and software and use the current Porsche test plan: a similarly named fault or a different active problem does not automatically match this bulletin.
Workshop approach
- Preserve complete transmission and engine faults, status and freeze-frame data. Record the selected mode, actual and requested gear, temperature, start-stop state, software identity and previous work before clearing or programming.
- Check for relevant recalls, service actions and guided tests for the exact VIN. Compare paddle and selector inputs, requested versus actual gear and related supply, network and control information where available.
- Follow current Porsche instructions for any programming, calibration and road verification. A software update does not repair an unrelated hydraulic, mechanical or electrical fault, and code labels and procedures should not be transferred between G1C, G1F, G1G and other PDK applications.
See Porsche PDK Macan and Panamera diagnosis and the electronic gearbox index.
For a separate modified 992 Turbo S and the limits of its reported PDK-slip diagnosis, see PDK and engine torque diagnosis. That high-load forum report is not the low-load manual shift condition in SY 24/23.