Tuning Wiki
Browse Pierburg

Where this sensor is used

This Pierburg air-mass sensor reports mass flow as a frequency, not as a 0 to 5 V level, and it has an intake-air temperature sensor in the same housing. It is the meter on the 1.6 litre diesel in these cars:

  • Citroën Berlingo, C2, C3, C4, C5, Jumpy and Xsara Picasso HDi
  • Ford Fiesta, Focus and Fusion TDCi
  • Peugeot Expert, Partner, 1007, 206, 207, 307, 308 and 407 HDi

Pierburg 7.28342.06.0 replaces 7.28342.04.0. Original-equipment numbers carried for the same meter are 9650010780, 1232096, 1255117, 3M5A12B579BA, 3M5A12B579BB, Y60113215, 1920GV and 30774680. A failing meter on these engines is associated with black smoke, lack of power, limp home, and fault codes P0100 to P0104.

Connector

PinFunction
1Temperature sensor
2Earth
3Not assigned
4Supply, 12 V
5Frequency output

A digital multimeter that can read frequency, or an oscilloscope, is required. A voltage-only check of pin 5 will not show the mass flow.

Supply

Unplug the sensor. Measure between pin 4 and pin 2 of the wiring connector, ignition on. The reading is on-board voltage, above 11 V. A low supply here is the feed or the earth, not the sensor.

Temperature

The control unit’s intake-air temperature, with the sensor connected, should match the air around the car. On the sensor itself, unplugged, resistance is measured between pin 1 and pin 2. Heat the sensor and read the temperature with a thermometer at the same time.

°CΩ
05846
252000
401128
60564
120103

Mass-flow frequency

Leave the sensor plugged in and in the intake. There is no workshop reference for the true mass, so the zero-flow point is the reference. Ignition on, engine stopped, measure frequency between pin 2 and pin 5. The setpoint is 5000 Hz ± 10 Hz. The rectangular signal swings up to about 12 V.

Start the engine and open the throttle. Frequency falls, and the pulses on the oscilloscope become further apart. That direction is the opposite of a Karman or AC Delco frequency meter, where frequency rises with flow. A frequency that stays at 5000 Hz once the engine is pulling air is a meter that is not seeing flow, or a signal wire that is not the frequency output.

At idle the trace is a square wave whose period depends on idle speed. With the pedal pressed the period is longer. Some engine testers can overlay a stored idle reference; the live idle trace should lie close to that reference. A Bosch HFM 5 on pin 5 is a rising analogue voltage. This Pierburg pin 5 is a falling frequency. The two cannot be compared on a voltmeter.