
MSPNP2 NS9501b is a vehicle-specific MegaSquirt-II-based plug-in ECU. The manufacturer’s documentation lists 1996–1998 Nissan S14/240SX according to the manufacturer index. Confirm the ECU part number, engine, harness, region and transmission before use.
Application and version
The shared installation guide describes the combined 1995–1998 KA24 range; verify the b suffix and connector on the actual unit. This page describes the manufacturer’s version 2.0 documentation. Different hardware versions, optional jumpers and configurations can change installation details.
Installation and pinouts
Refer to the NS9501b version 2.0 installation guide for its model-specific wiring diagrams, connector orientation, sensor configuration and setup instructions. Check the exact installed configuration; avoid applying the pinout of an MS3Pro PNP or another vehicle. The manufacturer’s manual index also links older version documents.
Select and verify the correct base tune, check timing as directed and tune the specific engine after installation.
Rear options connector — V2.0
The 26-way auxiliary connector table below is transcribed from the manufacturer's application guide. These are option-connector letters, not the main vehicle ECU connector. Check the source diagram for viewing orientation, jumper instructions, device configuration and current limits.
| Pin | Function | Manufacturer note |
|---|---|---|
| A | ADC1 | Ensure no jumpers installed in JP12–JP15 ADC1 positions |
| B | ADC2 | Ensure no jumpers installed in JP12–JP15 ADC2 positions |
| C | External MAP | Move JP6 jumper to EXT |
| D | IAT input | |
| E | Cam input | VR input 2 |
| F | Oxygen sensor input | EGO sensor port = Local |
| G | Table switch input | See jumper matrix JP14 |
| H | Knock input | See jumper matrix JP12 |
| I | Flex | Requires JP11 installed |
| J | Clutch input | See jumper matrix JP13 |
| K | 5 V reference | Maximum 0.5 A |
| L | Signal ground | |
| M | CAN low | |
| N | Output 2 | Incompatible if Spark C is used |
| O | CAN high | |
| P | Output 1 | Incompatible if Spark D is used |
| Q | Tachometer output | |
| R | Boost | See boost control section |
| S | Spark D | Incompatible if Output 1 is used |
| T | Injector D | |
| U | Spark C | Incompatible if Output 2 is used |
| V | Injector C | |
| W | Spark B | |
| X | Injector B | |
| Y | Spark A | |
| Z | Injector A |
The source guide does not establish every numbered vehicle connector assignment here; the table must not be used as a substitute for an application-specific OEM connector schedule.