
MSPNP2 MK9395 is a vehicle-specific MegaSquirt-II-based plug-in ECU. The manufacturer’s documentation lists 1993–1995 Ford Probe; 1993–1995 Mazda MX-6/626 2.5L V6; 1992–1994 Mazda MX-3 1.8L V6. Confirm the ECU part number, engine, harness, region and transmission before use.
Application and version
The manufacturer guide lists these chassis separately; confirm the Probe engine and connector with the supplier. This page describes the manufacturer’s version 2.0 documentation. Different hardware versions, optional jumpers and configurations can change installation details.
Installation and pinouts
Refer to the MK9395 version 2.0 installation guide for its model-specific wiring diagrams, connector orientation, sensor configuration and setup instructions. Check the exact installed configuration; avoid applying the pinout of an MS3Pro PNP or another vehicle. The manufacturer’s manual index also links older version documents.
Select and verify the correct base tune, check timing as directed and tune the specific engine after installation.
Manufacturer connector-label conflict: The optional wasted-spark section of the same MK9395 guide describes the three-pin ignition connections as an N76/front connector, but its adjacent chart labels A, C and E as “Rear Option Connector” pins for ignition A/B/C. The 26-way rear table below assigns A, C and E to different functions. Confirm the connector and jumper configuration with AMP before connecting these positions; do not assume the charts describe the same connector.
Rear options connector — V2.0
The 26-way auxiliary connector table below is transcribed from the manufacturer's application guide. These are option-connector letters, not the main vehicle ECU connector. Check the source diagram for viewing orientation, jumper instructions, device configuration and current limits.
| Pin | Function | Manufacturer note |
|---|---|---|
| A | ADC1 | Ensure no jumpers installed in JP12–JP15 ADC1 positions |
| B | ADC2 | Ensure no jumpers installed in JP12–JP15 ADC2 positions |
| C | External MAP | Move JP6 jumper to EXT |
| D | IAT input | |
| E | Cam input | VR input 2 |
| F | Oxygen sensor input | EGO sensor port = Local |
| G | Table switch input | See jumper matrix JP14 |
| H | Knock input | See jumper matrix JP12 |
| I | Flex | Requires JP11 installed |
| J | Clutch input | See jumper matrix JP13 |
| K | 5 V reference | Maximum 0.5 A |
| L | Signal ground | |
| M | CAN low | |
| N | Output 2 | Incompatible if Spark C is used |
| O | CAN high | |
| P | Output 1 | Incompatible if Spark D is used |
| Q | Tachometer output | |
| R | Boost | See boost control section |
| S | Spark D | Incompatible if Output 1 is used |
| T | Injector D | |
| U | Spark C | Incompatible if Output 2 is used |
| V | Injector C | |
| W | Spark B | |
| X | Injector B | |
| Y | Spark A | |
| Z | Injector A |
The source guide does not establish every numbered vehicle connector assignment here; the table must not be used as a substitute for an application-specific OEM connector schedule.