Tuning Wiki
Applies to

Check the hardware and software limits stated in this article.

MSPNP2 ECU product illustration
Manufacturer MSPNP2 product photograph used as a family illustration; vehicle-specific connectors and casing can differ. Image: AMP Engine Management; reproduced with permission.

MSPNP2 B8793 is a vehicle-specific MegaSquirt-II-based plug-in ECU. The manufacturer’s documentation lists 1987–1992 BMW E30 325 M20; 1989–1990 E34 525i; 1989–1993 E34 535i/M5; 1988–1992 E32 735i, manual transmission as specified. Confirm the ECU part number, engine, harness, region and transmission before use.

Application and version

Engine and production-year restrictions vary within the E32 and E34 list; check the guide and original ECU. This page describes the manufacturer’s version 2.0 documentation. Different hardware versions, optional jumpers and configurations can change installation details.

Installation and pinouts

Refer to the B8793 version 2.0 installation guide for its model-specific wiring diagrams, connector orientation, sensor configuration and setup instructions. Check the exact installed configuration; avoid applying the pinout of an MS3Pro PNP or another vehicle. The manufacturer’s manual index also links older version documents.

Select and verify the correct base tune, check timing as directed and tune the specific engine after installation.

Rear options connector — V2.0

The 26-way auxiliary connector table below is transcribed from the manufacturer's application guide. These are option-connector letters, not the main vehicle ECU connector. Check the source diagram for viewing orientation, jumper instructions, device configuration and current limits.

PinFunctionManufacturer note
AADC1Ensure no jumpers installed in JP12–JP15 ADC1 positions
BADC2Ensure no jumpers installed in JP12–JP15 ADC2 positions
CExternal MAPMove JP6 jumper to EXT
DIAT input
ECam inputVR input 2
FOxygen sensor inputEGO sensor port = Local
GTable switch inputSee jumper matrix JP14
HKnock inputSee jumper matrix JP12
IFlexRequires JP11 installed
JClutch inputSee jumper matrix JP13
K5 V referenceMaximum 0.5 A
LSignal ground
MCAN low
NOutput 2Incompatible if Spark C is used
OCAN high
POutput 1Incompatible if Spark D is used
QTachometer output
RBoostSee boost control section
SSpark DIncompatible if Output 1 is used
TInjector D
USpark CIncompatible if Output 2 is used
VInjector C
WSpark B
XInjector B
YSpark A
ZInjector A

The source guide does not establish every numbered vehicle connector assignment here; the table must not be used as a substitute for an application-specific OEM connector schedule.