Configuration and learned equipment
MS4X documents MS42 gearbox detection from EGS1 CAN traffic, defaulting to manual when absent, and A/C detection through INSTR3. It states that these results are stored and that repeating detection requires clearing learned variants. MS4X reference.
Record installed equipment, observed CAN communication and the learned state before deciding that a calibration switch is wrong. A missing message can arise from the wiring or the surrounding vehicle as well as the controller configuration. After a relevant repair or configuration change, document which adaptation operation was performed and verify what was learned.
Build an equipment worksheet
| Record | Evidence to keep |
|---|---|
| Transmission | Installed gearbox/controller, communication status and reported variant. |
| A/C and accessory load | Installed equipment, request data, idle response and the learned configuration. |
| Lambda system | Installed sensor arrangement, bank-specific feedback, readiness and faults. |
| MAF and camshaft control | Signal plausibility, substitute-state evidence and commanded/actual values where available. |
This worksheet is an editorial troubleshooting aid. Use the precise switch definitions in the matching software to interpret the stored configuration.
Preserve the fault before clearing it
Capture the original fault number, description, status, conditions and available freeze-frame data. Record both the controller-specific code and any translated P-code; keep the mapping source with the translation. Then compare the result after the repair or change. A clear operation removes evidence, so perform it at a documented stage.
Use the shared load guide to distinguish a sensor value from a calculated or substituted load. If a fault affects the active strategy, include that fact in the calibration evaluation rather than averaging its samples into a normal-operation result.
Sources and scope
Original reference notes by Tuning Wiki, informed by the linked MS4X Wiki pages. MS4X Wiki contributors and the authors credited by each linked project remain the source authors. Sources checked 10 November 2026. Suggested validation steps and worked arithmetic are editorial guidance; they are not a tested calibration or a claim of hardware verification.
- Siemens MS42 (revision 23721).