Tuning Wiki
Applies to

Check the hardware and software limits stated in this article.

AMP MSPNP-Pro Subaru WRX ECU
MSPNP-Pro SW0205 Subaru WRX version shown as a family illustration; this application has its own case and connector layout. Image: AMP Engine Management, reproduced with permission.

MSPNP-Pro MM0105 is a vehicle-specific MS3Pro-based plug-in engine management ECU. The manufacturer’s model-specific installation guide lists the following application: 2001–2005 Mazda Miata with manual transmission. Fitment depends on the original ECU connector, engine, harness and market; confirm the exact part number before installation.

Application and installation

The turbocharged 2004–2005 Mazdaspeed Miata is listed separately under MSM0405. Verify application before ordering. Plug-in does not mean every optional feature is prewired: follow the relevant guide for setup, sensors, jumpers, base tune and ignition-timing checks.

Pinout and documentation

AMP EFI MM0105 vehicle-specific installation and connector documentation is the primary source for this model. Check the connector orientation, version and any configurable or optional functions before wiring. Diagrams may be shown as images in the guide; this page does not substitute a pin assignment from another MSPNP model.

See the manufacturer’s ECU documentation index and firmware and base-tune index. Initial maps require verification and tuning for the particular engine.

Rear options connector — A–Z

From this model's AMP EFI installation guide. These are rear options connections; they do not constitute the full original vehicle ECU connector pinout. Check the manufacturer's connector orientation and configuration before wiring; functions marked as defaults are configurable.

PinFunctionDefault or note in source
ASensor ground—
BKnock sensor 2—
CAnalog input 2—
DAnalog input 1MAF
EIAT—
FExternal MAP sensor—
GCANL—
H+5 V reference—
ICANH—
J+12 V ignitionMaximum 0.5 A
KDigital frequency in 3—
LDigital frequency in 2VSS
MDigital in 2—
NClutch signal—
ODigital in 4—
PPWM2—
QHigh current 3Nitrous
RHigh current 2Boost control
SIgnition D logic level—
TInjector HHigh Z or GPIO only
UIgnition C logic level—
VInjector GHigh Z or GPIO only
WIgnition B logic level—
XInjector FHigh Z or GPIO only
YIgnition A logic level—
ZInjector E—