Tuning Wiki
Applies to

Check the hardware and software limits stated in this article.

AMP MSPNP-Pro Subaru WRX ECU
MSPNP-Pro SW0205 Subaru WRX version shown as a family illustration; this application has its own case and connector layout. Image: AMP Engine Management, reproduced with permission.

MSPNP-Pro EECV-8AM is a vehicle-specific MS3Pro-based plug-in engine management ECU. The manufacturer’s model-specific installation guide lists the following application: 1996–1998 Mustang GT or Cobra 4.6L with manual transmission. Fitment depends on the original ECU connector, engine, harness and market; confirm the exact part number before installation.

Application and installation

The manufacturer’s guide explicitly specifies manual transmission. Plug-in does not mean every optional feature is prewired: follow the relevant guide for setup, sensors, jumpers, base tune and ignition-timing checks.

Pinout and documentation

AMP EFI EECV-8AM vehicle-specific installation and connector documentation is the primary source for this model. Check the connector orientation, version and any configurable or optional functions before wiring. Diagrams may be shown as images in the guide; this page does not substitute a pin assignment from another MSPNP model.

See the manufacturer’s ECU documentation index and firmware and base-tune index. Initial maps require verification and tuning for the particular engine.

Rear options connector — A–Z

Transcribed from this application's AMP EFI installation guide. These are the rear options connections; they are not the complete factory vehicle connector pinout. Verify orientation, exact ECU variant, electrical limits and software configuration before wiring.

PinFunctionDefault or note in source
AAnalog sensor groundSensor return
B5 V VrefFused at 250 mA
CAIN2Fuel pressure sensor; duplicates main pin 63
D12 V supply outFused at 250 mA
EIATDuplicates main pin 39
FExternal MAP sensorInternal MAP sensor default
GEGOOptional wideband O2 sensor
HAnalog input 1MAF sensor; duplicates main pin 88
ICANL—
JDFIN1 conditionedOSS+ VR; VR sensors only; duplicates main pin 84
KCANH—
LDFIN2 conditionedAdditional speed sensor, VR sensors only
MDigital input 1Optional flex fuel
NDigital input 4—
ODigital input 2—
PDFIN3—
QDigital input 3A/C request switch; duplicates main pin 41
RTach outInstrument cluster
SPower ground—
THigh current output 3Low cooling fan; inverted on main pin 45
UHigh current output 1—
VHigh current output 2—
WPWM output 3A/C compressor; duplicates main pin 69
XInjector output JHigh impedance only
YPWM output 2High cooling fan; duplicates main pin 46
ZInjector output IHigh impedance only