MoTeC TCMux part 14002, Hall sensor wiring, drawing A01 revision C. The referenced drawing shows M4 and M8 ECU integration; M4 requires software V3.9 or later and M8 V4.1 or later. It limits wiring distance between multiplexer and ECU to 500 mm. Confirm connector orientation against the maker’s drawing. Pin 2 is not identified in that drawing.
| Pin | Function |
|---|---|
| 1 | 8 V supply input |
| 3 | Left rolling sensor 8 V |
| 4 | Right rolling sensor 8 V |
| 5 | Left driven sensor 8 V |
| 6 | Right driven sensor 8 V |
| 7 | 0 V supply input |
| 8 | Disable switch 0 V |
| 9 | Left rolling sensor 0 V |
| 10 | Right rolling sensor 0 V |
| 11 | Left driven sensor 0 V |
| 12 | Right driven sensor 0 V |
| 13 | Coded traction-control signal output to ECU |
| 14 | Traction-control disable switch |
| 15 | Left rolling sensor signal S1 |
| 16 | Right rolling sensor signal S2 |
| 17 | Left driven sensor signal S3 |
| 18 | Right driven sensor signal S4 |
Rolling and driven identify wheel function, not necessarily front and rear. The manufacturer publishes a separate magnetic sensor wiring drawing; do not transfer this Hall sensor arrangement to it. Source: MoTeC TC Mux Hall wiring diagram A01 rev C; MoTeC downloads.